HP N1528A Installation And User Manual page 44

Operation
Table 4-2. View ACL Options
Option
Drive and Slot Numbering
ACL Mode
Sequential Mode
LCD Contrast Adjust
Barcode Label Size
Barcode Label Alignment
Barcode Label Check
Digit
Barcode Reader
Module Configuration
N1528A and N1529A ACL Tape Drive Installation and User's Guide—544594-003
Description
Lets you specify whether SCSI elements in the ACL
displays with either zero-based or one-based. This affects
the GUI touch screen, not the actual SCSI element
addresses. The default is one based.
Lets you set the robotics operating mode to Random or
Sequential. The default is Random.
Lets you select a normal or recirculate frequency mode. The
default is Normal. (Only available if ACL Mode is set to
Sequential).
The LCD contrast controls let you increase or decrease the
contrast of the LCD display. The increment steps are set by
adjusting the LCD Contrast Adjust option from the ACL
option. Incremental steps can range from 0 to 31 depending
on your preference.
Lets you limit the maximum number of characters of the
barcode label. Possible settings are 1 through 8. The default
is 8.
Lets you specify the alignment of a barcode label. The
options are Left to Right. When used in conjunction with the
label size option, this option strips unwanted trailing
characters (left alignment) or leading characters (right
alignment). The default is Left Align.
Lets you specify whether to enable or disable the verification
of a check digit character in the barcode label. The default is
Disabled
Lets you specify whether the barcode reader will retry
reading barcode labels. The default is Retries Enabled.
Lets you specify the ACL Module Configuration. Three
options are available:
•
Standalone - Used when the ACL contains a single
module
•
Master - Used to select the module in a multi-module
ACL
•
Slave - Used to select the other modules in a multi-
module ACL
4- 12
View System Data