Table of Contents
Advertisement
Introduction to DBS T1 Networking
Pre-Installation Requirements
Use the following guidelines to prepare your site for T1 installation.
Ordering T1 Services
The following guidelines describe T1options that must be ordered from your
central office or interexchange carrier (if used). These guidelines are designed
to cover almost all T1 installations. However, special requirements should be
discussed with your provider.
Table 1-1. Guidelines for ordering T1 services
Item to be Ordered
Line Type
Trunk Signaling
Signaling Code
Line Code
Framing Format
Signaling Method
Tones
DBS-10-540
Options
E&M with wink start for both incoming and outgoing calls.
Wink start
DS-1
AMI
D4 (Superframe) or ESF (Extended Superframe). D4 is used in
most cases.
In-band
Coordinate with T1 Service Provider.
Note: If the CO does not provide dial tone, program the DBS to
generate its own dial tone.
T1 Networking - Issued 9/6/96
Pre-Installation Requirements
Page 9
Advertisement
Table of Contents
