Panasonic DBS Section 540 Reference Manual page 88

T1 Settings Added for Networking
Parameter
Description
Address
Options
Notes
Parameter
Description
Address
Options
Parameter
Description
Address
Options
Notes
Page 88
Incoming Dial Type
Specifies the incoming dial type for the network trunk
group; either rotary (dial pulse) or DTMF.
FF1 8# 4# 8# 3# (NWG)# 2# (0/1)#
0=Rotary Dial (Pulse Dial)
1=DTMF
DTMF must be enabled for Network Paging operation.
The DBS must be equipped with one or more MFR cards
for DTMF operation.
This command requires a system restart to take effect.
Dial Tone Output
Determines if Dial Tone is returned to a incoming network
trunk group call upon trunk seizure.
FF1 8# 4# 8# 3# (NWG)# 3# (0/1)#
0=No Dial Tone Output
1=Dial Tone
Delete Access Code (Future Use)
Removes the access code (network node number) from the
number outdialed on a network trunk group trunk. This is
used when connecting to a non-DBS PBX.
FF1 8# 4# 8# 3# (NWG)# 4# (0/1)#
0=Dial access code (node number)
1=Delete access code (node number)
When dialing a non-DBS node, the user dials the node
number followed by the appropriate PBX number. The DBS
removes the node number and outdials the remaining digits.
T1 Networking-Revised April 2000
Programming
DBS-2.3/9.2-540