Requirements; Identifying Phone Model; Phone Firmware - Panasonic KX-HDV230C Configuration Manual

This Configuration Guide is written as a general guide on how to configure the Panasonic phone
model KX-HDV230C to work with PBXware 5.3.8.

Requirements

Identifying Phone Model

To start and successfully complete the registration of your Panasonic phone, you need to know
which phone model to set up.
On the back of each Panasonic phone, there is model information that you should check.
Although various phone models can have exactly the same requirements and installation
procedures, phone models can also have significantly different requirements and installation
procedures, so that is why it is important to know the model you own which results in you
setting up the phone successfully.

Phone Firmware

Make sure that the phone is loaded with an appropriate firmware version, HDV230/11.180.
To find out the firmware version of the Panasonic phone model, open a new browser window
and enter the phone's IP address in order to access the phone's web administration interface
login screen. Example: http://192.168.1.22.
NOTE: The phone's web administration web interface is disabled by default. To enable
access, go to Settings --> Network Settings and enable the Embedded Web option.
Log in to the phone's web administration interface with the username and password. Please
note that the factory default login details are as follows: username is admin and password is
adminpass.