Table of Contents
Advertisement
USING A COMMAND SEQUENCE
Follow this procedure to use a command
sequence.
If
you have taught a command sequence to the
Turbo,
use
this procedure to test the
sequence.
If the sequence does
not work
properly,
use the procedure in "Editing a Com-
mand
Sequence"
to check and correct the
sequence.
If
it still doesn't
work,
individually test each key you used in
the
sequence.
1.
Point the Turbo directly
toward the component
that the sequence af-
fects.
Be sure all of the
components are within
the Turbo's control
range
.
2.Press [SEQ]
,
followed
by the command key
you used to designate
the sequence. The se-
quence name
(the
name you assigned to
the command key you
used to designate the
sequence) appears on
the display and re-
mains there until you
release the key. When
you release the key,
the IR indictor blinks
and the Turbo sends
the programmed se-
quence of
commands.
If you press a command
key you
have not
taught a command se-
quence,
ERROR ap-
pears on the
display.
3.
Press [CANCEL] to
clear the
display.
Note:
Sometimes a TV or VCR can be slow to re-
spond to a command. If this
happens,
you can
edit the sequence to lengthen the time the
Turbo transmits a
command.
See "Command
Extensions."
EDITING A COMMAND SEQUENCE
Use the following procedure to check or correct errors in
a command sequence.
1. Press [LEARN].
SE-
LECT and KEY alter-
nately appear on the
display.
15
Hide quick links:
Advertisement
Table of Contents
