Finishing; Louvre Bracket Installation; Door Removal & Installation; Logo Placement - Napoleon BGNV42N Installation And Operation Instructions Manual

8

LOUVRE BRACKET INSTALLATION

1. Align the holes in the louvre
brackets with the pre-drilled
holes in the firebox, as shown.
2. Secure louvre brackets in
place using screws.
DOOR INSTALLATION
The upper louvres must be removed to allow the door to be
removed. Release the two door latches, located across
the top of the door and lift off the lower door bracket.
GDL42 LOUVRE INSTALLATION
UPPER LOUVRE
15
DOOR LATCH
HINGE SCREEN
16
W415-0377 / 03.04.03

FINISHING

FIGURE 14
Insert the upper louvres into
the slots on both brackets.
Attach each hinge on the
lower louvre assembly to
the lip of the fireplace base
with 2 screws.
Position the hinge screen
into place and with the con-
trol door open, secure to the
fireplace using three
screws.
L42 LOUVRE INSTALLATION
FIGURE 17
A
B
S L O T
TA B
A
B
HINGE
S L O T
CLIP

LOGO PLACEMENT

Remove the
backing of the
logo supplied and
place on the glass
viewing door, as
indicated.
UPPER LOUVRES
Insert the louvre tabs into the
slots located at the top left and
right corners of the unit.
LOWER LOUVRES
Insert the hinge clips into the
slots located at the bottom left
and right corners of the unit.
To remove the louvres, pull the
back tabs of the clips forward,
while pushing the louvre assem-
bly back. Lift the clip.
½"
LOGO
½"
FIGURE 18