When Using The Multifunctional Digital Systems - Toshiba E-studio 5520c Safety Information Manual

1.GENERAL PRECAUTIONS
Other points
Make sure that there is enough space around the system to facilitate changing of parts, maintenance and clearing
paper jam.
If there is insufficient space, some operations, such as bypass feeding, will become difficult and the Multifunctional
Digital Systems could even break down.
To insure optimal operation, allow clearances of at least 80 cm (31.5") on the right, and 10 cm (3.9") on the left and
behind.
Be sure to fix the power cable securely so that no one trips over it.
Adverse environmental conditions may affect the safe operation and performance of the Multifunctional Digital
Systems, and the Multifunctional Digital Systems could break down.
- Avoid locations near windows or with exposure to direct sunlight.
- Avoid locations with drastic temperature fluctuations.
- Avoid too much dust.
- Avoid location that suffer from vibration.
Make sure that the air is able to flow freely and that there is sufficient ventilation.
With inadequate ventilation, the unpleasant odor released by ozone will begin to dominate the atmosphere.

When using the Multifunctional Digital Systems

Do not take off the cover of the equipment; otherwise you could be injured or get an electric shock.
Do not remove or connect the plug with wet hands, as this could give you an electric shock.
Do not place any container with liquid (flower vases, coffee cups, etc.) on or near the equipment.
This could cause a fire or give you an electric shock.
Keep paper clips and staples away from the air vent. If not, a fire could result or you could get an electric shock.
If the Multifunctional Digital Systems becomes excessively hot, smoke comes out of it or there is an odd smell or noise,
proceed as follows.
Turn the main power switch OFF and remove the plug from the outlet, then contact your service representative.
If the Multifunctional Digital Systems will not be used for more than one month, remove the plug from the outlet for
safety purposes during that time. If an insulation failure occurs, this could cause a fire or give you an electric shock.
Do not place heavy objects (4 kg/9 lb. or more) on the original glass and do not press on it with force. Breaking the
glass could cause personal injury.
Do not place heavy objects (4 kg/9 lb. or more) on the Multifunctional Digital Systems. If the objects fall off, this could
cause injury.
Do not touch the fuser unit or the metal area around it. Since they are very hot, you could be burned or the shock could
cause you to get your hand injured in the machine.
Be careful not to let your fingers be caught when closing the drawer. This could injure you.
Be careful not to let your fingers be caught between the equipment and the duplexing unit or automatic duplexing unit.
This could injure you.
Do not touch the metal portion of the guide plate in the duplexing unit or automatic duplexing unit as it could burn you.
Do not touch the hinge (= a connecting part) on the rear side of the Reversing Automatic Document Feeder. This could
catch and injure your fingers when you open or close the Reversing Automatic Document Feeder.
Always keep hands and fingers clear of FINISHER TRAY HINGE, as the tray could move unexpectedly. Failure to do
so could result in injury to your hand and/or fingers.
For e-STUDIO5520C/6520C/6530C
Be careful not to catch your fingers between the duplexing unit and its cover. This could injure you.
Do not touch the metal portion of the bridge unit as it could burn you.
10 cm
3.9"
Rear
Equipment
Left Right
10 cm
Front
3.9"
1 GENERAL PRECAUTIONS
80 cm
31.5"
General Precautions 21