5.
Set alarm sound volume
If you prefer:
No sound
A low beep
A louder beep
6.
c
Press
and repeat 2, 3, 4 and 5 to set remaining reminder alarms or
7.
Press and hold
Transferring Test Results To a Computer
appears on the display when you insert a data cable in the data port. The computer
must have a compatible data management system to complete the transfer. Remove
this cable before performing a test.
Contact Customer Care to learn more about the data management system.
29
ART22311-101_rev-B.indd 29-30
c
Press
until you see:
•
Press
m
for 3 seconds until meter turns off.
www.AbbottDiabetesCare.com
Maintaining the Meter
Replacing the Battery
Then
m
to save
The meter comes with a #2032, 3-volt, lithium battery installed. It provides power
for about 1000 tests.
•
When
appears on the display, the battery is low.
•
When
appears, the meter may fail to turn on.
IMPORTANT: When
appears, replace the battery immediately.
•
When you are ready to install a new battery, remove the old battery and
install the new battery within 60 seconds to avoid losing time and date
settings.
•
If time and date settings are lost, both time
flash until reset. Reset time and date to get the correct 7-, 14- and 30-day
averages. If the time and date settings are lost, you may still perform an
accurate blood glucose test.
•
Memory log and previously stored user settings, such as date and time
format, are not affected by removing the battery.
and date
will
30
8/28/14 11:30 AM