Powering; Using The Microphone; Introduction; Bass Cut Filters - AKG C314 User Instructions

Powering

3 Powering
ATTENTION

4 Using the Microphone

Introduction

Bass Cut Filters

Preattenuation Pads

Stand Mounting

24
The C314 matched stereo pairs thus provide the highest possible correlation
over the microphones' entire frequency range and virtually identical sensitivity for
stunning, three-dimensional recordings.
The C314 provides low self-noise yet high headroom. The microphone requires a
phantom power source providing 48 V ± 4 V as per IEC 61938.
Risk of damage
Do not connect the microphone to any power supply other than a phantom power
source (input with phantom power or external IEC 61938 standard phantom power
supply) with a floating connector, using a balanced cable with studio grade
connectors to IEC 268-12 only. This is the only way to ensure safe and reliable
operation.
The C314 features a smooth frequency response similar to the typical sound of
AKG large-diaphragm microphones.
You can use the C314 for most musical instruments in the studio and on stage
(see also section 3.5).
With its cardioid polar pattern, the microphone will give excellent results in a
multiplicity of recording situations, particularly, in close miking.
The selectable bass cut filter will effectively cancel out any unwanted noise such
as fan noise from air conditioning systems or low-frequency noise due to floor
vibrations, handling noise, etc. without affecting the sound of the recorded voice
or instrument on tape.
For details on the bass cut refer to the description of the operating elements.
The switchable preattenuation pads allow you to increase the microphone's
headroom. Remember to check that the equipment connected to the microphone
(microphone preamp, mixer input, recorder input) can handle the maximum
output level of the microphone without causing distortion.
For correct setting of the preattenuation, refer to the description of the operating
elements.
The supplied H85 shock mount has a standard 3/8" thread insert so you can
mount the microphone on almost every commercial stand or suspension with a
3/8" thread.
C314