NAPCO Gemini GEM-K2AS Operating Manual page 26

5. Enter the new User Code using the
number buttons. If an old code is
displayed, simply program over it.
Important: To erase the unused
digit(s) of the previous code, press
.
G 0
Note: Pressing again will dis-
R
play non-programmable "OPTion" and
"ACCess" screens. Do not attempt to
program these screens as the entries
will not be saved.
U
6. Press to save the code in mem-
ory. Repeat steps 3-6 for each user.
Note: To void a code, blank out each
digit by pressing
G 0
U
press the Save ( ) button.
Note: Duplicate Codes are not allowed;
therefore a duplicate Code entered in
the LCD Window will erase when
pressed.
26
P R O G R AM M I N G ( O P T I O N A L )
To Program User Codes
1. Using Number buttons,
enter User Number
2. Press R
3. Using number buttons,
enter User Code of up to
6 digits.
U
4. Press
5. Press
C
gram Mode.
, then
U
is
to save.
to Exit Pro-
Programming User Codes
Note: Press ,
G 0
character at cursor.
User01
to clear