Specifications; Operation - Ryobi RP4530 User Manual

GB
FR DE ES
SPECIAL SAFETY RULES
Do not crush, drop or damage battery pack. Do
Q
not use a battery pack or charger that has been
dropped or received a sharp blow. A damaged
battery is subject to explosion. Properly dispose of a
dropped or damaged battery immediately.
Q Batteries can explode in the presence of a source
of ignition, such as a pilot light. To reduce the risk
of serious personal injury, never use any cordless
product in the presence of open flame. An exploded
battery can propel debris and chemicals. If exposed,
flush with water immediately.
Q Do not charge the product in a damp or wet
location. Following this rule will reduce the risk of
electric shock.
For best results, your battery product should be
Q
charged in a location where the temperature is
more than 10°C but less than 34.4°C. To reduce the
risk of serious personal injury, do not store outside or
in vehicles.
Q Under extreme usage or temperature conditions,
battery leakage may occur. If liquid comes in
contact with your skin, wash immediately with
soap and water. If liquid gets into your eyes, flush
them with clean water for at least 10 minutes,
then seek immediate medical attention. Following
this rule will reduce the risk of serious personal injury.
SERVICE
Have your battery product serviced by a qualified
Q
repair person using only identical replacement
parts. This will ensure that the safety of the battery
product is maintained.

SPECIFICATIONS

Voltage
IP Rating*
*IP Rating: Specifies the environmental protection the
product enclosure provides. An IP Rating of 54 denotes
protection against harmful deposits of dust and protection
against water sprayed from all directions. The water
resistance rating applies only when the battery cap is
installed.
MODEL BATTERY PACK
RP4530 AP4001
IT NL PT DK SE
4 V
54
COMPATIBLE
CHARGER
AP4700
FI NO RU PL CZ
English
DESCRIPTION
1. Adjustable padded headband
2. Auxiliary input jack
3. Battery cap
4. Microphone
5 . On/Off/Volume knob
6. Battery pack
7. Battery compartment
8. Adjusting headband
9. Adjusting volume
10. MP3/Audio input cable

OPERATION

APPLICATIONS
This unit is an attenuating hearing protector. You may use
this product for the purposes listed below:
Noise reduction and voice amplification while using
Q
tools such as chain saws, mowers, leaf blowers, and
battery products.
Q Listening to auxiliary devices while working in high-
noise environments.
TO INSTALL / REMOVE BATTERY PACK
See Figure 2.
WARNING
Always remove battery pack from the product
when you are assembling parts, making
adjustments, cleaning, or when not in use.
ON/OFF/VOLUME KNOB
NOTE: The headphones will amplify sounds up to a pre-
determined sound level, in which it stops amplifying and
will deaden (block out) the sound.
The knob on the lower left earcup turns the noise
suppres-sion feature ON or OFF and adjusts the volume.
NOTE: The auto-off feature will shut the headphones off
after four hours if they are not in use.
AUTO POWER-OFF
The headphones will automatically shut down if they are
not in use for four hours.
LISTENING TO AUXILIARY DEVICES
WARNING
Do not use these headphones to listen to
music or other audio programs while operating
machinery. Doing so may cause distractions that
could result in serious personal injury.
2
HU RO LV LT EE
(See Figure 3.)
HR SI SK GR TR
(See Figure 5.)