Tires; Cutter Deck Gearbox - Scag Power Equipment STT61V-25KBD-SS Operator's Manual

3. Secure the cutter blades to prevent them from
rotating, (use the optional Blade Buddy tool, P/N
9212, to assist in securing the cutter blades), remove
the nut from the blade attaching bolt. Remove the
cutter blade, bolt and spacer from the spindle shaft.
(Figure 7-10)
The front of the machine will have to be raised
slightly to remove the blade bolt from the cutter
spindle.
4. To install the new cutter blade, put the flat washer
onto the blade bolt and slide the bolt into the hole in
the cutter blade.
HEX NUT-TORQUE
TO 75 LB-FT
SPINDLE
SHAFT
SPINDLE
ASSEMBLY
WASHER
Figure 7-10 Blade Replacement
Be sure that the blade is installed with the lift
wing toward the top.
5. Install the spacer onto the blade bolt and insert the
bolt into the cutter spindle shaft.
-NOTE-
CUTTER
DECK
HEX HEAD
BOLT / NUT
CUTTER BLADE
SPACER
CUTTER
BLADE
HEX HEAD BOLT
390S0160
-NOTE-
6. Install the hex nut to the blade bolt at the top of the
cutter spindle. Secure the blades from rotating and
torque to 75 ft/lbs. (See Figure 7-10)

7.10 TIRES

Check the tire pressures after every 8 hours of operation
or daily.
Caster Wheels ......................................... Flat Free
Drive Wheels ......................................... 12 PSI

7.11 CUTTER DECK GEARBOX

A. Checking Lubricant Level
CAUTION:
The cutter deck gearbox can reach high operating
temperatures. Allow the cutter deck gearbox to cool
before servicing.
CHECK
PLUG
Figure 7-12 Cutter Deck Gearbox
The fluid level in the cutter deck gearbox (Figure 7-12)
should be checked after every 100 hours of operation or
bi-weekly, whichever occurs first.
1. Lower the cutter deck to to its lowest position to
gain access to the cutter deck gearbox.
38
Section 7
CUTTER DECK
GEARBOX
390S0161