Tires; Body, Deck, And Upholstery - Scag Power Equipment CHEETAH II SCZII-61V-31FX Operator's Manual

Hide thumbs Also See for CHEETAH II SCZII-61V-31FX:
Table of Contents

Advertisement

R
HEX NUT-TORQUE
TO 75 LB-FT
SPINDLE
SHAFT
SPINDLE
ASSEMBLY
WASHER
Figure 7-10. Blade Replacement
- NOTE -
Be sure that the blade is installed with the lift wing
toward the top.
5. Install the spacer onto the blade bolt and insert the
bolt into the cutter spindle shaft.
6. Install the hex nut to the blade bolt at the top of the
cutter spindle. Secure the blades from rotating and
torque to 75 lb-ft. See Figure 7-10.

7.10 TIRES

Check the tire pressures after every 8 hours of operation
or daily.
Caster Wheels
Drive Wheels
CUTTER
HEX HEAD
BOLT / NUT
CUTTER BLADE
SPACER
CUTTER
BLADE
HEX HEAD BOLT
Flat Free
12 PSI

7.11 BODY, DECK, AND UPHOLSTERY

Do not wash any portion of the equipment while it
is hot. Do not wash the engine; use compressed
air.
DECK
1. After each use, wash the mower and cutter deck.
Use cold water and automotive cleaners. Do not use
pressure cleaners.
2. Do not spray electrical components.
3. Use a mild soap solution or a vinyl/rubber cleaner to
clean the seat.
4. Repair damaged metal surfaces using Scag touch-
up paint available from your authorized Scag dealer.
Wax the mower for maximum paint protection.
44
Section 7
CAUTION

Advertisement

Table of Contents
loading

Table of Contents