Temperature Recorder (Option) - Panasonic MDF-U4186S Series Operating Instructions Manual

TEMPERATURE RECORDER (OPTION)

If the warning is required for the internal temperature record or the interior temperature deviates from the
target temperature, an optional temperature recorder (MTR-85H) is available. Install the temperature
recorder properly as described below.
Warning indicator Warning indicator
Cover
1. Open the cover and let down the lever of the pen holder; the pen point is apart from the recording
paper. (Fig. 1)
2. Pull the cartridge out of the mounted position. (Fig. 2)
3. Set a new recording paper in place on the rear bottom of the cartridge. Set the hole on the recording
paper in the cog of the recording paper driving assembly and feed the recording paper in the direction of
the arrow by driving the cogwheel. (Fig. 3)
4. Set the recording paper recording to the mark of day and time.
5. When mounting, lay down the cartridge first, and push into the mounting position with the groove set at
the projection on the position.
6. Set up the cartridge and settle in position.
Replacement of cell
Replace the dry cell once a year as follows:
1. Put up the penholder first, then pull out cartridge from the
mounted position.
2. Reset the battery chamber cover with wire, on the bottom left
side, and take out the cell.
3. Set a new cell by turning its anode to this side.
4. Shut the cover after exchanging cells. Mount the cartridge as
before and lay down the penholder.
Note :
This temperature recorder is designed for the manganese dry cell
and the alkaline dry cell.
Do not use a rechargeable battery because the initial voltage of
such battery is low.
malfunction of recorder or shorten the battery life significantly.
Recording indicator
Pen holder
Cartridge
Fig. 1
The rechargeable battery may cause the
Temperature
Fig. 2
29
Time
Fig. 3
Cell