Troubleshooting - AcuRite 06027 Instruction Manual

Troubleshooting

Problem
No reception
no bars
Temperature is
showing dashes
Inaccurate forecast
Inaccurate temperature
or humidity
Display screen
not working
If the wireless signal indicator shows no bars:
• Relocate the display and/or synced Monitor/Sensor
(if applicable). The products must be within 330 ft
(100 m) of each other
• Make sure products (display, Monitors, Sensors) are
placed at least 3 feet (.9 m) away from electronics
that may interfere with the wireless communication
(such as TVs, microwaves, computers, etc).
• Use standard alkaline batteries (or lithium batteries
in Monitors and Sensors when temperature is below
-4ºF/-20ºC). Do not use heavy duty or rechargeable
batteries.
Note:
It may take a few minutes for display and
sensor to synchronize after batteries are replaced.
Dashes in the temperature reported by a Monitor/
Sensor is generally an indication of wireless interference
between the sensor and display.
1. Remove the Monitor/Sensor location from the display.
2. Re-add Monitor/Sensor to an available location on
display (see page 11).
• Weather Forecast icon predicts conditions for the next
12 to 24 hours, not current conditions.
• Verify at least one weather-resistant Monitor/Sensor
is placed outdoors with the location name set to
OUTDOOR. This is required for full weather forecast
functionality.
• Allow product to run continuously for 33 days.
Powering down or resetting the display will restart
Learning Mode. After 14 days, forecast should be
fairly accurate, however Learning Mode calibrates for
a total of 33 days.
• Verify the product that is reporting an inaccurate
temperature reading is placed out of direct sunlight and
away from any heat sources or vents (see page 8).
• Verify the product that is reporting an inaccurate
humidity reading is positioned away from moisture
sources (see page 8).
• Check that the power adapter is plugged into the
display and an electrical outlet.
15 15
Possible Solution