Setting Up The Art Usb Dual Pre To Use With Blue Sky Sro Software - BLUE SKY AMC Instruction Manual

Setting up the ART USB Dual Pre to use with Blue Sky SRO Software.

1) Plug the short TRS to XLR male cable from the Dual Pre right output to the Dual Pre right
microphone input.
2) Set the mix fader to computer (Max CW).
3) Set the output level straight up (12 O'clock).
4) Press the phantom switch to on.
5) Press the power to on.
6) Plug the measurement microphone into the Dual Pre left microphone input.
7) Set the left gain to 16.
8) Set the right gain to 1.
9) Plug the USB cable from the computer into the ART USB interface on the back. If it's the 1st
time the device is connected to the USB port you'll get a driver installation message.
10) Setup the ART as the default playback device and set its Playback properties.
Windows Control Panel-> Sound-> Playback ->USB Audio CODEC -> Set Default
Properties- >Advanced-> 16 bit, 48000Hz (DVD Quantity) -> OK.
11) Setup the ART Dual Pre as default recording device and set its recording properties.
Windows Control Panel-> Sound->Recording->Microphone USB Audio CODEC ->Set
Default
Properties-> Listen-> Uncheck ->Listen to device
Properties-> Levels-> 100.
Properties-> Advanced-> 2 channel 16bit, 48000 Hz ->OK.
NOTE: If you disconnect the ART Dual Pre from your computer, during the above setup, you may
have to go through this process again.
Page 26