Table of Contents
Advertisement
DIM/CANCEL – sets the system gain to a user defined level. The default setting is -30 dB. The
default setting can be changed using the menu or the AMC Control Software. The DIM/CANCEL
switch is also used to exit the menu mode
MUTE MODE – mutes the selected channels when the channel button is pressed.
SOLO MODE – solos the selected channels when the channel pressed.
SOLO/MUTE BUTTON – switches between modes
PRESETS – loads the preset.
MENU – switches the remote to menu mode, which allows a limited number of parameters to be
changed on a preset. When exiting the menu mode, the changed parameters are automatically
stored in flash memory.
GAIN – changes the system gain in increments of +/- 1 dB. Also used to scroll through the menu
and change parameters.
The Menu
You enter the menu by pressing the Menu switch and leave the menu by pressing the Dim/Cancel
switch. The menu works in 2 modes. A scroll mode to scroll the parameters using the gain control.
And a parameter mode to change parameters using the gain control. To switch between modes,
you tap the Menu switch. When you tap the Dim/Cancel switch to leave the menu mode, the
preset is automatically saved with the updated parameters.
An example of using the MENU to change the left calibration to +3 dB.
1) Tap the Menu switch.
2) Rotate the gain control to cycle through the menu items to Left Cal.
3) Tap the Menu switch to enter parameter mode.
4) Rotate the Gain control CW or CCW until the display reads +3.0 dB.
5) Tap the Menu key to go back to scroll mode.
6) Tap the DIM/CANCEL button to exit the menu and store the preset.
7) To change multiple items, follow 1-5 on each parameter and then hit the Dim /Cancel
button when you have completed all your changes.
Page 10
Advertisement
Table of Contents
