Table of Contents
Advertisement
GB
SEttINg.uP.thE.
1
DEvICE
Please read the safety information
before operating.
If you decide to use the wa-
ter filter: screw in the filter
only after the water tank starts up
and the device has been rinsed,
First, check the voltage on
once again, with at least 200 ml of
the nameplate (see under-
water. Activate the set-up of "Wa-
side of machine).
ter filter – on" Refer to the instruc-
4
tions in "Setting the parameters:
water filter" (see page 58).
If the device was exposed
to freezing temperatures,
please wait at least 3 hours before
turning on, so that the device can,
once again, warm up to room
temperature. A frozen or very cold
device may not function correctly.
Re-insert the water tank.
7
Rinse the device 4x before
the first use. Press the rinse
button again, after the completion
of the rinsing process.
Risk of scalding!
Very hot water.
Press rinsing button,
rinsing runs.
42
Bedienungsanleitung_GB.indd 42-43
2
11
3
max.
3.5.l
Remove the water tank.
Fill the water tank with
fresh water.
5
6
On
Briefly press the on/off but-
Close lever completely.
ton. Device heats up.
Situate container.
8
8
11
9
Wait for the end of the rins-
Device is ready.
ing process. Then, empty
the container.
1
A
max.
110.mm
Adjust the drip tray to the
With the upper drip tray.
desired cup size.
2
3
If present, remove the bottom
Adjust height of the spout.
flap of the capsule. Open
Close lever and press bev-
lever and insert capsule.
erage button.
5
6
8
Beverage preparation con-
Open lever, capsule falls
cludes.
into capsule container.
PREPARINg.DRINkS.
b
(Ex..bLACk.tEA)
Risk of injury!
Do not reach into the
max.
capsule insertion opening.
160.mm
The device will automati-
cally
operate
to the default, when it is not
used. If necessary, turn on and
With the lower drip tray.
clean the device again, before
beverage preparation, with the
on/off button (see page 42).
Important: only insert the capsule
4
after rinsing takes place.
The spout can be shifted up
or down with a pushing de-
vice (both sides of the spout).
Risk of scalding!
Very hot beverage. Do not
open the lever during the brewing
Brewing process runs, with dif-
process. Do not reach under the
ferent brewing cycles, depend-
spout.
ing on the button pressed.
By
repeatedly
11
7
any button, the brewing
process can be stopped.
For hygienic reasons, rinse
the device once after every
beverage preparation.
Off
To shut off, briefly press the
on/off button.
GB
according
pressing
43
28.05.15 15:39
Advertisement
Table of Contents
