Table of Contents
Advertisement
GB
FREquENtLy.ASkED
quEStIONS
Switch off the unit, unplug the mains plug and allow to cool to room temperature. After
that insert the mains plug and switch on again. If error occurs again, contact Service
Centre.
Switch off the device and unplug it. Wait at least 1 minute, Then insert the the mains
Caution!
plug and switch on again. If error occurs again, contact Service Centre.
The device is designed for
Beverage output is not working properly?
beverage capsules of all those
brands that are marked with the
Lever fully down. If necessary, device descaling – see section "cleaning, descaling and
K-fee® System Logo.
changing the filter as required".
The use of non-original cap-
Beverage discharge occurs with delay?
sules may involve the follow-
Device heats after.
ing risks: Health hazards, dam-
age to the device and the
Capsule container is crowded and jammed?
possible loss of warranty claims.
By gently shaking, try to remove the capsule container.
After inserting a capsule, the lever can not be closed completely?
Make sure that there isn't an already used capsule in the brewing chamber, the capsule
is not crowded and the newly inserted capsule is in the correct position.
Beverage is not hot enough?
If necessary, device descaling – see section "cleaning, descaling and changing the filter
as required".
All of the beverage symbols won't stop blinking slowly?
In such a case, turn off the device and let it cool down before it is put back into service.
Reset device to factory settings?
Switch off the device and unplug it. Hold rinse button and black tea buttons simultane-
ously. Insert the power cord and release both buttons. To confirm, the beverage symbols
briefly light up on the display twice.
What is the Eco Mode?
The device switches off automatically and returns to the eco mode when it is not used
within 30 minutes (factory setting). In Eco Mode, the device consumes significantly less
power (less than 0.5 W) compared to an operational, heated state.
62
Bedienungsanleitung_GB.indd 62-63
All these symbols are blinking quickly?
All these symbols are blinking quickly?
220 – 240 V ~, 50 Hz, max. 1455 W
1 m
P
max. 19 bar
approx. 3.5 l
approx. 4.5 kg
A = 200 mm
C
B = 406 mm
A
C = 316 mm
B
max. 160 mm
10 °C – 45 °C
~ 94 °C
Noise less than 70 dB (A)
If you have any questions and
suggestions, please contact us through
www.tealoungesystem.com/service
Information for automatic switch-off
The device switches off auto-
significantly less power (less than 0.5 W)
matically and returns to the eco
compared to an operational, heated state.
mode when it is not used within
If you still want to change these param-
30 minutes (factory setting). For
eters, please observe the instructions in
the environment, we recommend that you
the chapter "Setting the parameters: auto-
keep the factory setting.
matic switch-off".
In Eco Mode, the device consumes
tEChNICAL.DAtA.
GB
AND.SERvICE
63
28.05.15 15:41
Advertisement
Table of Contents
