Revo RCHB24-1 User Manual page 9

< Waterproof Sealing* >
* The waterproof sealing (black rubber) is attached inside of the camera.
 Lens: Fixed lens is installed.
 IR LED: The sensor (black) in the upper middle detects low illumination and the IR LEDs are
lit at night or under low lighting conditions. The factory reset button (white) in the bottom middle
will only be used on the rare occasions that you want to return all the settings to the original
factory settings.
 Body: The cables are connected through the body.
 Cable
− Video Out (BNC): Connect to a monitor. This is intended for video preview while adjusting
the camera.
− Network Port: Connect a Cat5 cable with an RJ-45 connector. You can manage the camera
or upgrade the software via the network connection. Refer to the INIT User's Manual for
details. The camera can be supplied with power over Ethernet cable by connecting to a
PoE-enabled RJ-45 port.
 Sun Shield Screw Hole: Allows you to screw the sun shield to the camera.
NOTE: Camera surveillance may be prohibited by laws that vary by region. Check the laws in
your area before using this product for surveillance purposes.
CAUTIONS:
 The network connector is not designed to be connected directly with cable or
wire intended for outdoor use.
 Make sure that the waterproof sealing is held into the camera body tightly when
reconnecting the lid after removing it to perform a factory reset. If the waterproof
sealing is not held into the camera body properly, the IP66 level is not guaranteed.
Ask your dealer or distributor for details.
< Cable >
< Sun Shield >
① Video Out
② Network Port
< Bracket >
Network Camera
3