Advertisement
Quick Links
Advertisement
Related Manuals for Revo RCPTS700-1
Summary of Contents for Revo RCPTS700-1
- Page 1 Model No.: RCPTS700-1 PAN/TILT DOME CAMERA INSTRUCTION MANUAL V0.1...
-
Page 2: Safety Precautions
Thank you for purchasing this product. Before installing the camera, please read this instruction manual carefully to ensure proper usage. Safety Precautions Take care when installing the camera. Do not connect power unless the camera’s gimbal is free to turn normally. After initial configuration, do not apply power to the camera until the installation is complete. - Page 3 range of -13°F (-25° C) to +122°F (+50°C). Only operate the camera in environments with non-condensing humidity levels less than 90%. Do not install the camera near the air outlet of an air conditioner or heater, or in any environment with rapid temperature fluctuations.
- Page 4 Automatic protocol detection: Pelco-D and Pelco-P. Settable baud rate. Adjustable motor speed. 212 presets (saved horizontal and tilt angle views) can be saved and retrieved. Auto Tour - The camera can automatically tour through any of 8 different ordered lists, each containing as many as16 presets. Auto Scan –...
- Page 5 5. RS-485 Address, Protocol, and Baud Rate Setting. Address (ID) setting: Set DIP switches 1 (least significant bit) through 8 (most significant bit) to set the RS-485 address of the camera. The address can be set from 0 through 255, and must be matched to the RS-485 address (often called the “ID”) in use by the controlling DVR or joystick keyboard.
- Page 6 Baud rate setting: Set DIP switches 9 and 10 to set the RS-485 baud rate of the camera. The baud rate can be set to 2400, 4800, 9600, or 19200 bps. Make sure that the baud rate of the camera matches the baud rate of the controlling DVR or joystick keyboard.
- Page 7 For example, if the REVO Mini Keyboard is being used to control the camera, “set” and “call” can be performed by doing the following: A “set”...
- Page 8 Function Function Function Description Number “Set” to save view, “Call” to move camera to view. 1 - 16 Presets “Set” to save view, “Call” to move camera to view. 17 - 32 Presets “Set” to save view, “Call” to move camera to view. Preset “Call”...
- Page 9 Function Function Function Description Number “Set” this function number to change the Auto Tour Pause Time Auto Tour pause time to 2 seconds. “Set” this function number to change the Auto Tour Pause Time Auto Tour pause time to 4 seconds. “Set”...
- Page 10 7. Pan/Tilt Dome Camera Installation Unscrew the dome camera’s transparent dome. Set the DIP switches for the desired address (ID) and baud rate. Use an RS-485 DVR or joystick keyboard to verify the camera’s operation. When proper RS-485 operation has been verified, reattach the dome, securing it tightly.
- Page 11 Connect the camera’s BNC video cable and RS-485 wiring to your DVR and (optional) joystick keyboard. Ensure that the camera’s RS-485 “+” wire is connected to the controlling device’s “+” or “A” connection. Also ensure that the RS-485 “-” wire is connected to the controlling device’s “-”...
-
Page 12: Specifications
Specifications Model No.: RCPTS700-1 Image Sensor SONY EFFIO-E CCD 1/3” Image Sensor Size Video Signal NTSC Resolution 700TV (Color) 976 horizontal, 494 vertical Effective Pixels 0.05LUX in Black-and-White “Night” mode Minimum Illumination 58dB White Balance Auto 1/60 to 1/12000 sec.