Table of Contents
Advertisement
ASSEMBLING THE AM LOOP ANTENNA
1 Rotate the outer frame of the antenna
2 Insert the bottom edge of the outer frame into the groove on the stand.
3 Extend the antenna cord
CAUTION
To avoid damage the speakers by inputting a sudden high-level signal, be sure to switch the power off
before connecting the speakers.
Connect the cable from each speaker to the corresponding terminal on the rear of the receiver.
• Most speaker cables have different markings, textures or colors to help you tell the difference between
negative and positive.
• Be sure to connect the positive (+) terminal on each speaker to the positive (+) terminal on the receiver.
Similarly, connect the negative (-) terminal on the speaker to negative (-) terminal on the receiver.
NOTES
• Use speakers with a nominal impedance of 8 ohms or more.
HOW TO CONNECT
1 Strip back the cable covering by about 1 cm and twist the wire strands together.
2 Turn the terminal cap counterclockwise to loosen it. The speaker terminal caps cannot be fully
removed from the base.
3 Insert the wire into the terminal fully and turn the terminal cap clockwise to securely connect it.
4 Make sure it is fastened firm by pulling the cable lightly.
CONNECTING ANTENNAS
Insert into the groove
CONNECTING SPEAKER SYSTEMS
7
Hide quick links:
Advertisement
Table of Contents
