Related Manuals for NAD C720BEE
Summary of Contents for NAD C720BEE
- Page 1 C720BEE ® Stereo Receiver Owner’s Manual Manuel d’Installation Bedienungsanleitung Gebruikershandleiding Manual del Usuario Manuale delle Istruzioni Manual do Proprietário Bruksanvisning...
- Page 2 IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS • Save these instructions for later use. • Follow all warnings and instructions marked on the audio equipment. 1 Read instructions - All the safety and operating instructions should be read before the product is operated. 2 Retain instructions - The safety and operating instructions should be retained for future reference.
- Page 3 THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE APPLIANCE CAUTION Changes or modifications to this equipment not expressly approved by NAD Electronics for compliance could void the user’s authority to operate this equipment. CAUTION REGARDING PLACEMENT To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer dimensions including projections) equal to, or greater than, shown below.
-
Page 4: Rear Panel Controls
ABOUT THE C 720BEE REAR PANEL CONTROLS FRONT PANEL CONTROLSFRONT PANEL CONTROLS ANTENNA Serial No./No. De Series GN D RECORD OU T VIDEO AU X TAPE PR E O UT MAI N I N IR IN DISC ZON E 2 +12V TRIGGER OU T... -
Page 5: Remote Controls
PRESS IN AND LIFT TAB TO REMOVE BATTERY COVER OUT FROM RECESS PLACE BATTERIES INTO OPENING. ENSURE THE CORRECT POLARITY IS OBSERVED ABOUT THE C 720BEE REMOTE CONTROLS VIDEO DISC IN 4 TAPE 1 TAPE 2 IN 5 IN 6 SOURCE LOCAL PRESET... -
Page 6: Notes On Installation
If the unit is not going to be used for some time, disconnect the plug from the AC socket. Should water get into your NAD C720BEE, shut off the power to the unit and remove the plug from the AC socket. Have the unit inspected by a qualified service technician before attempting to use it again. - Page 7 12V trigger input. This output will be 12V when the C720BEE is on and 0V when the unit is either off or in standby. This output can drive a load up to 50mA at 12V.
- Page 8 Stand-by mode: The Stand-by indicator will light up amber. Upon selecting any input at the front panel or the ON button of the remote, the C720BEE will choose the last selected as the active input. NOTE: The remote control handset supplied with the C720BEE is of a universal NAD type, designed to operate several NAD models.
-
Page 9: Remote Control Handset
When a command from the remote control is received, the Standby/protection indicator will blink. 1 POWER ON & OFF - The NAD C720BEE remote has a separate On and Off button. This can be particularly useful to keep components within a system "insync": This way all components will switch to stand-by... -
Page 10: About Antennas
SELECTING THE RADIO Press the AM or FM key on the C720BEE front panel, the SR-5's [TUNER] key to select the receiver's radio mode. Each subsequent press of [TUNER] key will toggle the unit between its FM and AM bands. - Page 11 NOTE: The one can store the same channel in two preset locations; one with FM Mute On, and with FM Mute Off. NOTE: Toggling between FM Mute on or off also defeats the C720BEE's FM muting circuit. If you wish to listen to a particularly weak or distant broadcast, toggle off the FM Mute and tune it manually.
- Page 12 SPECIFICATIONS PRE-AMP SECTION LINE LEVEL INPUTS(DISC, CD, VIDEO, AUX, TUNER, TAPE) LINE LEVEL OUTPUTS TONE CONTROLS IR / TRIGGER OUT POWER AMP SECTION (maximum continuous power per channel 4Ωand 8Ω) Input impedance (R and C) 22kΩ+ 100pF Input sensitivity (1V out) 330mV Maximum input signal Signal / noise ratio pre-amp out, A-weighted...
-
Page 13: Tuner Section
TUNER SECTION Input sensitivity 50dB Harmonic Distortion; Harmonic Distortion; Signal / noise; Signal / noise; Stereo separation at 1kHz; Frequency Response; PHYSICAL SPECIFICATIONS Dimensions (W x H x D) Net weight Shipping weight 1 From CD input to speakers output, volume setting for 500mV in, 8Ω 1W out 2 Minimum power per chnnel, 20Hz - 20kHz, both channels driven with no more than rated distiortion. - Page 14 TROUBLESHOOTING PROBLEM NO SOUND NO SOUND ON ONE CHANNEL WEAK BASS/ DIFFUSE STEREO IMAGE REMOTE CONTROL HANDSET NOT WORKING NO SOUND WITH TUNER NOISE, HISS ON AM AND FM DISTORTION ON FM WHISTLES OR BUZZES ON FM & AM WHISTLES OR BUZZES ON AM NO RDS NAME (PS) CAUSE •...
- Page 15 ©2005 NAD ELECTRONICS INTERNATIONAL A DIVISION OF LENBROOK INDUSTRIES LIMITED All rights reserved. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International C 720BEE Manual 0105 Printed in China...