Osd (On Screen Display); Automatic Osd Function - NAD L 76 Owner's Manual

When your NAD Surround sound Receiver is connected to a television, you can operate the unit with the
remote control by making selections from on-screen menus. If a menu remains on the screen for a period
of time without a selection being made, the display will disappear. Most menus disappear after 12 seconds.
Important: The on-screen display will not operate unless the receiver is connected to the television with a
video or s-video cable from the monitor out jacks.
Before using the on-screen display, the ON SCREEN SELECTOR SWITCH on the rear panel of the receiver
must be set to the type of video connection being used to supply video signal from your receiver to your
TV monitor.
• VIDEO : Set the switch to this position when using the yellow VIDEO MONITOR OUT jack.
• S-VIDEO : Set the switch to this position when using the 4 pin S-VIDEO MONITOR OUT jack.
The on-screen display will only appear when the video signal matches the type of signal selected with the
selector switch.
AUTOMATIC OSD FUNCTIONS
If the receiver is connected to a television with a video cable from the monitor out jacks, the following
functions when used , will appear on-screen automatically.
SLEEP
Pressing the SLEEP button on the remote control brings up a display that allows you to select the amount
of time from 90 to 0 minutes after which the system will shut itself off. Once the display appears, each time
you press the SLEEP button reduces the time in ten minute increments. At zero, pressing the SLEEP button
again starts the sequence over at 90 minutes. Without input, the display will disappear in 7 seconds.
VOLUME
Pressing the MASTER VOLUME button on the remote control brings up a display that shows the receiver
volume selected.
INPUT STATUS
When you turn your receiver's power on or change its functions, a display appears on your television
screen showing the current status of the system, including the type of video and audio input being
monitored, the type of audio output.
With this display on-screen, the type of input being monitored can be changed by pressing the
appropriate key in the top section of the remote control. This menu will remain on the screen for only 7
seconds without input.
VIDEO
DVD
AUDIO
DVD
TUNER
VIDEO 1 VIDEO 2
VIDEO 1 VIDEO 2
TAPE AUX

OSD (ON SCREEN DISPLAY)

19