Operation; Using The T 775 - Main Menu; About The On-Screen Display (Osd); Main Menu - NAD T775 Owner's Manual

ABOUT THE ON-SCREEN DISPLAY (OSD)

The T 775 receiver employs a simple, self-explanatory system of on-screen display "menus" that will
appear on the connected video monitor/TV. These are required during the setup process (and are
useful in day-to-day operation), so be sure to connect the monitor/TV before proceeding with setup.
DISPLAY THE OSD
Press either or ENTER buttons of the HTR 3 remote control or front panel to display the T 775's Main
Menu on your video monitor/TV. If the OSD does not appear, check your MONITOR OUT connections.
NAVIGATING THE OSD AND MAKING CHANGES
To navigate through the OSD menu options, please do the following using the HTR 3 or corresponding
front panel buttons:
1. Press or ENTER to select a menu item. Use
down the Menu selections. Repeatedly press
desired menu item.
2. Use
keys to set or change the parameter value (setting) of a menu item.
3. Press
to save the settings or changes done on the current menu or sub-menu. Pressing
also return the user to the previous menu or exit from a particular menu.

MAIN MENU

The Main Menu contains the menu options for 'Listening Mode, ' 'DSP Options, ' 'Tone Controls, ' 'Zone
Controls' and access to 'Setup Menu. '
To navigate through these Main Menu options and their sub-menu selections, please refer to and
follow the directions stated in the sections 'Display the OSD' and 'Navigating the OSD and Making
Changes. '
NOTE
The individual configurations set forth at 'Listening Mode, ' 'DSP Options' and 'Tone Controls' are
carried over whenever they are enabled during A/V Preset setting. Please see the section 'AV Presets'
for reference.

LISTENING MODE

The T 775 offers nine distinct listening modes, tailored for different types of recording or program
material. With a two-channel (Stereo) source, the following listening modes can be selected:
STEREO
All output is directed to the front left/right channels. Low frequencies are directed to the subwoofer
if one is present in the Speaker settings. Select 'Stereo' when you wish to listen to a stereo (or
monaural) production, such as music CD or FM broadcast, without surround enhancement. Stereo
recordings whether in PCM/digital or analog form and whether surround-encoded or not encoded,
are reproduced as recorded. Multi-channel digital recordings (Dolby Digital and DTS) are reproduced in
"Stereo Downmix" mode via the front left/right channels only as Lt/Rt (left/right-total) signals.
DOLBY PRO LOGIC
Two-channel recordings, whether stereo or surround-encoded, are reproduced with Dolby Pro
Logic surround processing, yielding output to front left/right, center and discrete left/right surround
channels (assuming these are present in the current 'Speaker Configuration'). The surround channel is
monophobic, but it is reproduced in both surround speakers.
DOLBY PRO LOGIC PLII
Dolby Pro Logic II is a more recent evolution of the original Dolby Pro Logic surround processing that
yields more stable imaging and full bandwidth sound to the rear channels in Movie mode, offering
sound that is more similar to Dolby Digital decoding.
keys or in some cases, ENTER, to move up or
to advance or go further into sub-menus of a

OPERATION

USING THE T 775 – MAIN MENU
will
1