Auto Learn - Datalogic DS4800 Reference Manual

RAPID CONFIGURATION

Auto Learn

If you are configuring your scanner using X-PRESS™, you must start with the Auto Learn
procedure.
1. Enter the Auto Learn function by holding the X-PRESS™ push button pressed until the
LEARN LED is on.
2. Release the button to enter the Auto Learn function.
Once entered, the reader starts a procedure to automatically detect and recognize
barcodes (by type and length), which are presented to it (*). The laser turns on and the
LEARN LED blinks to indicate the ongoing process.
READY
GOOD
TRIGGER
LEARN
COM
TEST
STATUS
Figure 6 – X-PRESS™ Interface: Auto Learn Function
3. Exit the process by pressing the X-PRESS™ push button once. The scanner will restart
at the end of the process, and then the detected barcodes are automatically configured in
scanner memory.
If the barcode cannot be read because of low contrast or excessive ambient
light, you can perform the AutoSetup function to optimize the optical
parameters. Then you can perform AutoLearn to recognize the barcode
symbology.
NOTE
* In case of Programming Barcodes (refer to the "ID-NET™: Programming Barcodes And Setup Procedure"
document in the product CD).
SETUP
The procedure is as follows:
A) place the desired barcode on the
scanline.
B) wait until the LEARN LED stays
green
steady on (indicating the reader
has detected the barcode).
green
C) repeat, if needed, the above two
yellow
steps to program up to 10
yellow
different barcodes (the LEARN
LED returns to the blinking state
red
for the next code). If more than
one barcode is detected in the
scan line, the Multi Label mode is
enabled (refer to the "2K/4K
Family
Parameter Guide" Help file).
Software Configuration
1
7