Hyundai HYLS7000V User Manual page 13

7.10. Place log onto splitter.
7.10.1. Place the log onto the support table vertically and sitting flat on the support
table.
7.10.2. Make sure the wedge and support table makes contact with the log squarely on
the ends.
7.10.3. NEVER attempt to split a log at an angle.
ALWAYS split log in the direction of its growing grain.
DO NOT place log across the log splitter for splitting. It can be dangerous
and may seriously damage the machine.
7.11. Adjust the log holders (A) according to the diameter of the log to obtain most
comfortable control levers angle.
7.12. Hold the log with clamping brackets closely in the control lever guards. Lower
levers to start the splitting.
7.12.1. Releasing either lever stops the motion of the splitting wedge.
7.12.2. Releasing both handles will return the splitting wedge to the upper position.
7.13. Stack cut wood as you work. This will provide a safer work area, by keeping it
uncluttered, and avoid the danger of tripping, or damaging the power cord
Accumulated split wood and wood chips can create a hazardous work
environment.
NEVER continue to work in a cluttered work area which may cause you
to slip, trip or fall.
7.14. Replacing hydraulic oil.
7.14.1. The hydraulic system is a closed system with oil tank, oil pump and control valve.
7.14.2. Check oil level regularly with dipstick. Low oil levels can damage the oil pump. Oil
Level should measure approx. 10~20mm lower than the upper surface of the oil
tank.
7.14.3. The oil should be completely changed once a year.
7.14.3.1. Make sure moving parts have stopped and the log splitter has been
unplugged.
Page 13