Assembly - Hyundai HYLS7000V User Manual

6. ASSEMBLY

6.1. Put washers as shown, then a
wheel followed by the axle. Push
axle through the wheel, then
through the 3 washers, through
frame and fasten with the spring
clip .Finally place the wheel cover.
Repeat for second wheel.
6.2. Wheel assembly pack (part A of
hardware parts) contains;
6.2.1. 2 x wheel covers.
6.2.2. 2 x axles.
6.2.3. 6 x washer.
6.2.4. 2 x spring clips.
6.3. Pull the spring clip (A) to remove the
locking pin (B).
6.4. Apply a thin coat of grease to both
surfaces of the control lever guard as
illustrated. Insert the control lever
and guard assembly and make sure
the control lever end goes into the
slot of connection bracket (C). Lock
the control lever and guard assembly
down with the locking pin (B) and
spring clip (A). Follow the same steps
to install the other control lever and
guard assembly on the other side.
6.5. Assembly pack B of hardware parts
contain;
6.5.1. 2 x locking pins.
6.5.2. 2 x spring clips.
Page 10