Related Manuals for Dogtra 1400NCP
Summary of Contents for Dogtra 1400NCP
- Page 1 REMOTE CONTROLLED DOG TRAINING COLLARS OWNER’S MANUAL Copyright c 2006 Dogtra Company 2006- www.dogtra.com...
-
Page 2: Table Of Contents
CONTENTS MAIN FEATURES PRODUCT SAFETY AND HEALTH STATEMENTS COLLAR PACKAGE CONTENTS DESCRIPTION OF TRANSMITTER PARTS DESCRIPTION OF COLLAR / RECEIVER PARTS BATTERY CHARGER CHARGING THE BATTERIES TESTING YOUR COLLAR OPERATING INSTRUCTIONS ACCESSORIES WARRANTY AND REPAIR INFORMATION... -
Page 3: Main Features
Do not attempt to test dogtra e-collars on Over 3000 different identity codes to humans or other animals. prevent conflicts with other e-collars. -
Page 4: Collar Package Contents
PACKAGE CONTENTS TRANSMITTER COLLAR DESCRIPTION OF PACKAGE CONTENTS TRANSMITTER PARTS Transmitter transmitter Receiver (two collar receivers for two-dog models) Battery charger and splitter cable Antenna Test light Intensity Owner’s manual Selection Dial Indicator Light Selection Switch “Nick” Button “Pager” Button “Constant”... - Page 5 TRANSMITTER TRANSMITTER TWO-DOG MODELS Collar Selection Switch 2 Antenna (2-dog models) Transmitter Antenna A short 2” antenna is supplied with the transmitter. Selection Switch on the The antenna should be screwed into the top of the transmitter to ensure that the signals are The two-dog models have a toggle switch sent properly to the collar receiver and that on the face of the transmitter located above the...
- Page 6 TRANSMITTER TRANSMITTER Transmitter Charging Receptacle Intensity Selection Dial Transmitter Battery Charging Receptacle Intensity Selection Dial The intensity selection dial is located on the Located on the side of the transmitter, the receptacle is covered by a rubber plug. Insert top of the transmitter: (0) being the lowest level one end of the battery charging cable into the and (100) being the highest.
-
Page 7: Button Function
TRANSMITTER BUTTON FUNCTION BUTTON FUNCTION Nick Transmitter Indicator Light (LED window) The transmitter indicator light is located near Pager Constant the intensity selection dial. When a button on the transmitter is pushed, the light comes on to indicate that the transmitter is being activated. The color of the light indicates the status of battery life. -
Page 8: Description Of Collar / Receiver Parts
BUTTON FUNCTION COLLAR / RECEIVER DESCRIPTION OF “Nick” Button COLLAR / RECEIVER PARTS When the “Nick” button is pushed the receiver emits a single, rapid pulse of electrical collar stimulation. “Constant” Button Pressing the “Constant” button gives continuous stimulation as long as the button is Collar strap pushed, for up to twelve seconds. - Page 9 COLLAR / RECEIVER COLLAR / RECEIVER green = full charge, amber = medium charge ON/OFF Button red = needs charge When the “Constant” button on the transmitter is pushed, the collar indicator light will glow steadily as long as you hold the button down, for up to twelve seconds.
- Page 10 COLLAR / RECEIVER COLLAR / RECEIVER Receiver Charging Receptacle Fitting The Collar On The Dog Receiver Battery Charging Receptacle The collar should be fitted so that the On the inside of the collar, next to the collar stainless steel contact points press firmly against strap, is a battery charging receptacle with a the dog’s skin.
-
Page 11: Battery Charger
BATTERY CHARGER CHARGING THE BATTERIES BATTERY CHARGER CHARGING THE BATTERIES Charging Cable 120 volt Charger Two-dog unit only The battery charger and charging cables allow uses Ni-MH (Nickel-Metal-Hydride) you to charge both the transmitter and receiver at batteries that do not set a memory and can be the same time. - Page 12 CHARGING THE BATTERIES CHARGING THE BATTERIES 2. Do not charge the batteries near any Battery Charging Procedure flammable substances. 1. Attach the charging cables to both the transmitter and receiver(s), as shown on 3. Fully charge the batteries for 14 hours if page 19.
-
Page 13: Testing Your
TESTING TESTING TESTING YOUR 2. Watch the test light as you push the “Nick” button on the transmitter. It should light for just a moment. COLLAR 3. Watch the test light as you push the “Constant” button on the transmitter. It should glow brightly. -
Page 14: Operating Instructions
OPERATING OPERATING OPERATING INSTRUCTIONS Intensity selection To select the intensity level, start on the zero Fitting the collar (0) setting. Gradually increase the level until you get a response from the dog that would be The collar strap should be adjusted so that equivalent to a quick pull or jerk with a leash. - Page 15 OPERATING RECEPTION Maintenance Reception The receiver and collar strap should be cleaned periodically with detergent and water to collar has a half-mile range. Depending on the prevent malfunction. way you use your transmitter, the transmitting range may vary. Hold the transmitter away Always clean and rinse the collar thoroughly from your body and avoid touching the antenna with tap water after use in salt water.
-
Page 16: Accessories
To Qualify for the Limited Lifetime Warranty: Fill out the warranty registration card that came with your Dogtra unit and mail it in along with a copy of your purchase receipt within 30 days of purchase. Or, you can register your... - Page 17 REPAIR completed in a timely manner on a first-come, registration is not completed within 30 days of first-served basis. Dogtra is not responsible for purchase and/or the product is resold, the warranty loss of training time or inconvenience while the will become void and all repairs will be subject to unit is in our warehouse for repair work.
Need help?
Do you have a question about the 1400NCP and is the answer not in the manual?
Questions and answers