Operating The Samsung Side-By-Side Refrigerator; Setting Up The Refrigerator - Samsung RSA1W Series User Manual

operating the SAMSUNG
side-by-side refrigerator

SETTING UP THE REFRIGERATOR

Now that you have your new refrigerator installed and in place, you are ready to set up and enjoy the full
features and functions of the appliance.
By completing the following steps, your refrigerator should be fully operational. If not, first check the power
supply and electricity source or try the troubleshooting section at the back of this user guide. If you have
any further questions, contact your Samsung Electronics service center.
1. Place the refrigerator in an appropriate location with reasonable clearance between the wall
and the refrigerator. Refer to installation instructions in this manual.
2. Once the refrigerator is plugged in, make sure the interior light comes on when you open the
doors.
3. Set the temperature control to the coldest temperature and wait for an hour.
The freezer should get slightly chilled and the motor should run smoothly.
4. After powering the refrigerator, it will take a few hours to reach the appropriate temperature.
Once the refrigerator temperature is sufficiently cool, you can store food and drink in the
refrigerator.
USE ICE TRAY(OPTIONAL)(RSA1W,RSA1R)
When the freeze temperature get zero degre below, you can use Ice Box to make ice.
Pull out the ice tray.
Pour cool water into the
tray until it reaches the
water level indicator on
the tray.
Pull out the ice tray.
Pour water into the tray
until it reaches the water
level indicator on the tray.
_ setting up
26
Place it inside ice tray.
Turn ice tray button and the
ice automatically full into
the below ice compartment
after release. Pull out ice
storage compartment for ice.
Place it under the freezer
shelf or on the freezer shelf.
To separate individual ice
cubes, pull out the ice tray
and hold the ice tray by its
ends, then twist it gently.