DOORS...17 INSTALLATION INSTRUCTIONS INSTALLATION OF THE REFRIGERATOR ...18 REMOVING THE FRONT LEG COVER ...19 REMOVING THE REFRIGERATOR DOORS ... 20 REATTACHING THE REFRIGERATOR DOORS...22 ADJUSTING THE CLEARANCE BETWEEN THE DOORS...25 CHECKING THE WATER DISPENSER LINE ...27 INSTALLAING THE WATER DISPENSER LINE...28 TROUBLESHOOTING...33...
• The refrigerator only use ice makers which made by samsung Electronics for the refrigerator. • The incorporated ice-makers are to be installed only by the manufacture or its service agent.
Page 3
If the refrigerator is not to be used for a long period of time, pull out the power plug. • Deterioration in the insulation may cause fire.
SETTING UP THE REFRIGERATOR Once you have performed the following steps, your refrigerator should be fully operational. If not, check the power supply and electricity source. If you have any questions, contact your SAMSUNG service center. Place the refigerator in an appropriate location with reasonable clearance between the wall and the refigerator.
FRIDGE TEMP. BUTTON To set the fridge temperature, press the but- ton repeatedly to change the set tempera- ture in sequence between 7°C and 1°C. POWER COOL BUTTON Speeds up the cooling process in the refrigerator...
Page 6
CONTROL PANEL Basic Model (With CoolSelect Zone) Cool Select zone Dispenser Model (With CoolSelect Zone) Cool Select zone...
• This light is on when you press the Power Cool button. Power Cool Press the button to quickly return the refrigerator to the set temperature. • Press the button again to cancel the Power Cool mode. • This light indicates the recyclable deodorizer is in operation.
• When ice cream is stored above -15°C in freezer, it may melt. • The temperature of the freezer or the refrigerator rises from frequent openings, when sweeping and from warm food. This may cause the digital display to blink . The digital display will stop WARNING blinking when the freezer and refrigerator return to the normal temperature.
SHELVES AND BINS FREEZER Basic model REFRIGERATOR Door Bin Light Shelf Twist ice maker Ice tray Drawer Front leg cover Model with ice and water dispenser Dairy compartment Lights Wine Self(Optional) Door Bin Beverage Station Foldable Shelf(optional) Deodorizer (optional) Egg Container...
FOOD STORAGE GUIDE FROZEN FOOD STORAGE IN FREEZER Tempered Glass Shelf • Can be used to store all types of frozen food. Door Bin • Can be used for small packages of frozen food. Plastics Drawer • Can be used to store meat and dry foods. Stored food should be wrapped securely using foil or other suitable wrapping materials or containers.
Page 11
• Place your wine bottle on the shelf to maintain their taste. • If you have a long vacation planned, you must empty the refrigerator and turn it off. Wipe excess moisture from the inside and leave the doors open. Otherwise, odor and mold may develop.
• “Chill” temperature helps keep meat or fish fresh longer. Cool • When “Cool” is chosen, the temperature will be the same as the set temperature of the refrigerator. The digital panel shows the same temperature as that of the display panel.
CoolSelect Zone Drawer GUIDE “Quick Cool” button • You can use the Quick Cool feature with the CoolSelect Zone • “Quick Cool” allows 1~3 canned beverages to cool within 60 min. • To cancel this option, press the “Quick Cool” button again. CoolSelect Zone returns to the previous temperature.
In addition, this saves energy. • Before removing the freezer and refrigerator accessories, please move the stored foods to other space. • The door of the Beverage Station should never be removed. WARNING The Beverage Station •...
Rubber door seals • If the rubber door seals are dirty, the door will not close properly and the refrigerator and freezer will be unable to function efficiently. Clean them with a mild detergent and damp cloth. Then wipe them with a dry cloth.
Before changing the interior light, unplug the appliance from the power supply. If you experi- ence difficulty when changing the light, contact your service centre. WARNING INTERIOR LIGHT IN THE FREEZER (BASIC MODEL ONLY) / REFRIGERATOR Place a flat screwdriver under the light cover hooks and push in the direction of the arrow.
• You can not use the water and ice dispenser without a water filter cartridge because of the water line block at the water supply. Ordering replacement filters • To order more water filter cartridges, contact your authorized Samsung dealer. DOORS The refrigerator doors have a special door opening and closing feature to make sure that the doors close all the way and are securely sealed.
Checking the Dimensions of your Entrance Door • Check the dimensions of your entrance door to determine whether the refrigerator can pass through it. • Moving refrigerator through door if depth or width of refrigerator is bigger than door’s, NOTE removes refrigerator doors.
REMOVING THE FRONT LEG COVER Removing the Front Leg Cover (Optional) Open the freezer and refrigerator doors, and then take off the front leg cover assembly by turning the three screws counter-clockwise. Separating the water supply line from the refrigerator (Optional) 1) Remove the screw from clamp ( ).
REMOVING THE REFRIGERATOR DOORS • Lift the door straight up. • Be careful not to pinch the water tubing and wire harness on the door. NOTE • Place doors on a protected surface. Removing the Freezer Door 1) With the door closed, remove the upper hinge cover ( ) using a screwdriver, and then disconnect the wires ( ).
( ). lower hinge ( ) by lifting the lower hinge ( ) in the direction of the arrow. • After disassembling the freezer / refrigerator door, move it to the appropriate location. you must reassemble it. NOTE...
REATTACHING THE REFRIGERATOR DOORS Reattaching the Freezer Door 1) Insert the lower hinge ( ) in the bracket lower hinge ( ). 3) Insert the upper hinge shaft ( ) into the hole ( ). After levelling the upper hinge hole ( ) with the hole of the cabinet ( ).
( ). Fasten hinge screws ( ) and screw ( ) in the clockwise direc-tion. 4) Connect the wires. 2) Place the hole in the refrigerator door ( ) over the lower hinge ( ).
Page 24
REATTACHING THE REFRIGERATOR DOORS Reattaching the Water Tube (Optional) 1) While pressing the front face of coupler ( ), insert the water line ( ) in the coupler. 2) Tighten the screw on the clamp ( ). Reattaching the Front Leg Cover (Optional) Put on the front leg cover by turning the three screws clockwise, as shown in the figure.
ADJUSTING THE CLEARANCE BETWEEN THE DOORS Please level the refrigerator first. The doors will be uneven if the refrigerator is not level. Case 1) Freezer door is lower than that of the refrigerator Case 2) Freezer door is higher than that of the refrigerator Do not make small adjustment by turning the control lever, Please refer to the next page.
ADJUST THE CLEARANCE BETWEEN THE DOORS Making small adjustments between doors. If the door of the freezer is lower than that of the refrigerator. Adjustment part Please open the doors and adjust the doors as follows: 1) Release the nut ( ) on the lower hinge until the upper end of the bolt ( ).
3) If the refrigerator is installed in an area with low water pressure (below 1.4kgf/cm a booster pump to compensate for the low pressure. 4) Ensure the water storage tank inside the refrigerator is preperly filled initially. Push the water dis penser lever until the water runs from the outlet.
- Locate the nearest cold drinking water line. - Follow the instructions in the ice maker installation kit. Connect the water line to the refrigerator - Slip the compression nut and plastic ferrule through the plastic tube.
- Reattach the compressor cover of the refrigerator. Secure the water line. - Using clip ”A”, fix the water line to the wall (the back of refrigerator). - When the water line is secure, make sure whether the water line is not excessively bent, pinched or squashed.
INSTALLING THE WATER DISPENSER LINE For Exterior model Connect to the water supply line Connect the water pipe with coupler and tap. - Close the main water tap. - Connect coupler “A” to the tap. - Every join should be protected with sealing tape. WARRANTY INFORMATION This water line installation is not covered by the refriger-ator or ice maker manufacturer's warranty.
Page 31
Connect the water line to the refrigerator. - Remove the compressor cover of the refrigerator. - Connect the water line to the valve, as shown in the fig-ure. - When connected, check if there is any leakage.
Page 32
3) Additional flushing may be required in some households. 4) Open the refrigerator door and check if water leaks around the water filter. • A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser.
• Is the refrigerator in direct sunlight or located near a heat source? • Is the back of the refrigerator too close to the wall? The food in the refrigerator is frozen • Is the temperature control on the display panel set to the correct temperature? Try seting it to a warmer temperature.