Media Length Measurement; Detailed Features - Oki LD620D User Manual

5. Detailed features

5-1 Stand-alone Configuration Mode
Various modes can be executed by using button and LED status.
Please take following steps to start Stand-alone Configuration Mode and execute each
function.
1) Make sure that a printer is in Print Standby Mode.
2) Depress the Feed button for about 3 seconds, then the LED changes to orange color.
3) Release the Feed button, then the printer starts the Standalone Configuration Mode and
6 numbers of LED status changes sequentially.
4) When the Feed button is depressed at specific LED status, the corresponding operation
will be executed.
Function List of Stand-alone Configuration Mode.
Sequence
Number
Color
1 Green
2 Orange
3 RED
4 Green
5 Orange
6 Red
* This information can be printed out by printer self-test.

5-2 Media Length Measurement

The printer needs to have the exact length of currently installed paper to make a proper
print image.
For this, the printer automatically starts Media Length Measurement Mode in the following
conditions.
1) When the printer has no measure length, for example first feeding after installation.
2) When the detected label length differs from the measured value.
In this mode, the printer feeds 2 or 3 labels to measure the exact length of label and saves
the measured value on printer's non-volatile memory.
Rev. 1.0
LED
Status
Blink 3 times NONE
Blink 3 times Factory Reset and Gap Calibration
Blink 3 times Factory Reset and Black Mark Calibration
Keep On NONE
Keep On Data Dump Mode
Keep On Demo Mode
- 17 -
LD620D
Printer Operation