Troubleshooting - Ecom Instruments Ex-Handy 05 Safety Instructions

may be that the aforementioned limitations and exclusions are not valid for every
purchaser. Should any such clause of these warranty conditions be declared
ineffective or unenforceable by a competent court, then the effectiveness or enfor-
ceability of any of the other conditions of these warranty conditions shall remain
unaffected by such a judgement.

12. Troubleshooting

Please note that the latest information and new points concerning troubleshooting
measures can be found on the ecom instruments GmbH website under Service >
Troubleshooting.
Problem
The phone won't switch on.
When the phone is charging the
keypad illuminates, but the display
remains blank.
When the phone is charging the
keypad flashes and nothing appears
in the display.
„E" is displayed by the network sym-
bol (bar indicator).
The phone „freezes" (display is on, no
functions are possible).
Remedy
Press and hold the power button for
approx. 6 seconds. If nothing hap-
pens, charge the battery
If the battery is severely depleted, it
may take up to 20 minutes before the
display appears.
If the display doesn't reappear after 20
minutes, disconnect the charger from
the power supply and re-insert it after
1 minute.
Disconnect the phone from the
charger, remove the battery and then
re-insert it again. Reconnect the
charger to the phone and switch it on.
If the problem persists, please contact
the ecom instruments GmbH service
department.
It is only possible to make emergency
calls.
Relocate to a position with a better
reception.
Take out the battery and remove the
SIM card. Then replace the SIM card,
re-insert the battery and switch on the
phone.
27