Setting The Timer Functions - Rheem 3 Owner's Manual And Installation Instructions

TIMER FUNCTIONS
Function
Clock
STD/AUTO
Set ON/OFF
Times
Sleep Delay Time
Filter Life*
Service Menu
*Boiling Water Units do not have a water filter however filter life functions can be
utilised if the water supply to the BWU has a water filter fitted.
To select a Timer Mode
Press the (Prog) button until the desired mode is displayed on the screen. Press the
(Accept) button to confirm selection. Pressing (Cancel) button at any time returns
the unit to the main menu. Any functions previously accepted will be retained.
Note: The display will revert back to main menu from any mode if a button has not
been pressed for 1 minute.
SETTING THE TIMER
Mode
N/A
STD
AUTO
N/A
N/A
Remaining Life
Filter Reset
Set Filter Life
Error Codes
Boiling Temp
Calib. Reset
Temp Override
Software Version
Temp Show
ON/OFF
TB Treq
Description
Set clock time.
BWU 'ON' 24 hours 7 days.
BWU operates according to programmed 'Set
ON/OFF Times'.
Program ON/OFF times for AUTO mode.
Program delay-off
(operates in AUTO mode only).
Displays remaining filter life in litres.
Resets filter 'Remaining Life' to 'Set Filter Life'
setting. Utilised when replacing filter.
Program filter life start value in litres.
Displays alpha error codes (refer to page
error codes and their meanings).
Displays the current boiling water temperature in
ºC.
Reactivates automatic boiling point calibration
operation.
Manually select
Selectable from 70 – 99 ºC.
Displays Timer and Controller software versions
(top = Timer, lower = Controller).
Enable/disable boiling water temperature display
on timer screen (in ºC).
Displays boiling water temperatures in ºC. (TB =
calibrated temp, Treq = maintained temp).
7
time from last
calibrated temp
usage
11
for
setting.