Burner Ignition Lighting With A Match; To Extinguish Burner - Weber Q 3200 Owner's Manual

BURNER IGNITION
Lighting with a Match
A) Open the grill lid (1).
DANGER
Failure to open the lid before igniting
the grill's burners, or not waiting five
minutes to allow the gas to clear if the
grill does not light, may result in an
explosive flare-up which can cause
serious bodily injury or death.
B) Make sure ALL burner control knobs are turned
off (2). Check by pushing burner control knobs in and
turning them clockwise until they stop.
WARNING: The burner control knobs
must be in the off ( ) position before
you turn on the LP cylinder valve. If
they are not in the off ( ) position
when you turn on the LP cylinder
valve, the "excess gas flow control"
feature will activate, limiting the flow of
gas from the LP cylinder. If this should
occur, turn off the LP cylinder valve
and burner control knobs. Start over.
DANGER
When the "excess gas flow control"
feature is activated, a small amount of gas
is still flowing to the burners. After turning
off the LP cylinder valve and burner
control knobs, wait at least five minutes
for the gas to clear before attempting to
light the grill. Failure to do so may result
in an explosive flare-up, which can cause
serious bodily injury or death.
C) Turn the LP cylinder on by slowly turning the cylinder
valve counterclockwise (3).
D) Strike a match and put the flame under the matchlight
hole (4). While holding lit match, light the outside
burner by pushing the large burner control knob in and
turning it counterclockwise to start/high ( ) position (5).
E) Check that the burner is lit by looking through the
cooking grates. You should see a flame.
WARNING: Do not lean over the open
grill while igniting. Keep your face and
body at least 12 in (30 cm) away from
the matchlight hole when lighting the
grill.
WARNING: If the burner fails to ignite
within five seconds, stop, turn the
burner control knob to off and wait
five minutes to allow the gas to clear
before you try again or light with a
match.
F) After the outside burner is lit, you can turn on the
inside burner. Push in the small burner control knob
and turn it to start/high ( ) position (6). The inside
burner will then be ignited by the outside burner.

TO EXTINGUISH BURNER

Push each burner control knob in and turn it clockwise to
the off ( ) position. Turn gas supply off at the source.
BURNER IGNITION & USAGE
2
3
4
6
1
5
27
WWW.WEBER.COM
®