Mercury Xi5 Wireless Edition Manual page 49

OWNER SERVICE ASSISTANCE
NOTE: If all four buttons on the remote are not pressed simultaneously within
ten seconds, or a long beep is not heard, unplug the battery cables from the
power source and then refer to Activating the Wireless Foot Pedal and
Activating the Handheld Remote
Battery Information
REPROGRAMMING THE WIRELESS FOOT PEDAL OR REMOTE
NOTE: This activation procedure applies to the foot pedal and handheld
remote.
IMPORTANT: To activate multiple foot pedals or remotes, the motor must be
unplugged from the power source and then plugged back into the power source
between activating each control device.
1. Unplug the battery cables from the power source. Wait 30 seconds and
then plug the motor into the power source.
2. In less than ten seconds, press and hold the left arrow and right arrow
buttons on the handheld remote. For the foot pedal controller, hold the
propeller and anchor button simultaneously.
FOOT PEDAL BATTERY REPLACEMENT
Battery required: Two AA alkaline batteries
1. Remove the two screws securing the battery cover plate. Remove the
battery cover plate.
2. Remove the batteries from the battery holder.
3. Install the new batteries in the proper orientation for correct polarity.
eng
section of this manual.
a b
in the Product Installation, Wiring, and
a - Battery cover plate
b - Screws
a
51760
43