8
Tightening the V-belt
.01.02
Fig. 8 - 02
8
Fitting the upper belt guard
.01.03
4
5
Fig. 8 - 03
Mounting and commissioning the machine
1
1
3
2
Loosen nuts 1.
Tighten the V-belt using the dolly
switch 2.
Tighten nuts 1.
Fig. 8-02 shows a Quick motor. If
another motor is used proceed as
described in the instruction
manual!
2
If a large balance wheel is in
use, break off corner 1 of belt
guard part 3.
Screw stop piece 2 onto belt guard part 3.
Screw on belt guard part 3 onto the
housing.
Screw on belt guard part 4 onto the
housing.
Secure belt guard parts 5 and 6 onto the
table top.
6
8 - 2