Installing The Transmitter Batteries; Battery Led Monitor - Spektrum DX2L Manual

EN
BIND PLUG COMPARTMENT
INSTALLING ThE
TRANSMITTER BATTERIES

BATTERy LED MONITOR

ST. TRIM
TH. TRIM
MIN MAX
ST. D/R
Solid Green Battery is good (Above 4V)
Flashing Green Battery voltage is critically low. Replace batteries
(below 4V)
TRANSMITTER COMPATIBILITy
The Spektrum DX2L transmitter is compatible with all
®
™
Spektrum DSM , DSM2
2
Bind Plug Compartment
®
and Marine surface receivers.
INSTALLING ThE RECEIVER
IN yOUR VEhICLE
Electric Vehicle Installation
Vehicle
Electronic
Speed Control
Receiver
2.4Ghz DSM
SR200
THR
SPORT SURFACE
RECEIVER
STR
BIND
Steering Servo
Typical Nitro Vehicle Installation
Receiver
2.4Ghz DSM
SR200
THR
SPORT SURFACE
RECEIVER STR
BIND
Install the receiver in your vehicle using double-sided foam
servo tape. Foam servo tape holds the receiver in place and
protects the receiver from vibration. Position the antenna
vertically and away from the vehicle in an antenna tube.
CAUTION: Do not cut the antenna.
SETTING ThE FAILSAFE POSITIONS
Failsafe positions are set during binding. In the unlikely event
that the radio link is lost during use, the receiver moves the
servos to their preprogrammed failsafe positions, normally
full brakes and straight steering, to prevent a vehicle from
running away. If you power the receiver on before powering
on the vehicle, the receiver enters the failsafe mode. Normal
control resumes when you power the transmitter on.
SPEKTRUM DX2L USER GUIDE
To Motor
Throttle Servo
Steering Servo
Receiver Battery