Procedure For Tilting Down; (Power Trim And Tilt Models); Shallow Water; Cruising In Shallow Water (Manual Tilt Models) - Yamaha F25D Owner's Manual

Operation
EMU33121
Procedure for tilting down (power
trim and tilt models)
1. Push the power trim and tilt switch "
(up) until the outboard motor is support-
ed by the tilt rod and the tilt support knob
becomes free.
2. Pull out the tilt support knob.
3. Push the power trim and tilt switch "
(down) to lower the outboard motor to
the desired position.
UP
DN
DN
DN
54
"
EMU28061
EMU28073
Cruising in shallow water (manual tilt
models)
EWM01781
WARNING
ZMU06545
Run the boat at the lowest possible
●
speed when using the shallow water
"
cruising system. The tilt lock mecha-
nism does not work while the shallow
water cruising system is being used.
Hitting an underwater obstacle could
cause the outboard motor to lift out of
the water, resulting in loss of control.
Use extra care when operating in re-
●
verse. Too much reverse thrust can
cause the outboard motor to lift out of
the water, increasing the chance of ac-
cident and personal injury.
ZMU01936
ECM00260
NOTICE
Do not tilt the outboard motor up so that
the cooling water inlet on the lower unit is
above the surface of the water when set-
ting up for and cruising in shallow water.
Otherwise severe damage from overheat-
ing can result.
ZMU04901

Shallow water

DN
ZMU06546