Power Trim And Tilt Switch On Remote Control Or Tiller Handle; Power Trim And Tilt Switch On Bottom Cowling; Trim Tab With Anode - Yamaha F25D Owner's Manual

EMU26143
Power trim and tilt switch on remote
control or tiller handle
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pressing the switch "
outboard motor up, and then tilts it up. Press-
ing the switch " " (down) tilts the outboard
motor down and trims it down. When the
switch is released, the outboard motor will
stop in its current position.
For instructions on using the power trim and
tilt switch, see pages 48 and 51.
DN
EMU26154
Power trim and tilt switch on bottom
cowling
The power trim and tilt switch is located on
the side of the bottom cowling. Pushing the
switch " " (up) trims the outboard motor up,
and then tilts it up. Pushing the switch "
(down) tilts the outboard motor down and
" (up) trims the
ZMU04899
UP
trims it down. When the switch is released,
the outboard motor will stop in its current po-
sition.
For instructions on using the power trim and
tilt switch, see page 51.
EWM01031
WARNING
Use the power trim and tilt switch located
on the bottom cowling only when the boat
is at a complete stop with the engine off.
Attempting to use this switch while the
boat is moving could increase the risk of
falling overboard and could distract the
operator, increasing the risk of collision
with another boat or an obstacle.
1. Power trim and tilt switch
EMU26244

Trim tab with anode

EWM00840
WARNING
An improperly adjusted trim tab could
cause difficult steering. Always test run
after the trim tab has been installed or re-
placed to be sure steering is correct. Be
sure you have tightened the bolt after ad-
justing the trim tab.
The trim tab should be adjusted so that the
steering control can be turned to either the
"
right or left by applying the same amount of
force.
Components
1
ZMU06495
UP
DN
23