Operation - Panasonic EY6225 Operating Instructions Manual

6225.p06-09EN 05.06.01 0:49 ページ6
Read "Safety Instructions" booklet
and the following before using.
I ADDITIONAL
SAFETY RULES
1) Be aware that this tool is always in an
operating condition, since it does not
have to be plugged into an electrical
outlet.
2) When drilling into walls, floors, etc.,
"live" electrical wires may be
encountered. DO NOT TOUCH THE
CHUCK OR ANY FRONT METAL
PARTS OF THE TOOL! Hold the tool
only by the plastic handle to prevent
electric shock in case you drill into a
"live" wire.
3) If the
immediately turn the main switch off to
prevent an overload which can
damage the battery pack or motor.
Use reverse motion to loosen jammed
bits.
4) During charging, the charger may
become slightly warm. This is normal.
Do not leave the battery in the charger
for more than 24 hours after charging
is completed.
5) Use only a dry, soft cloth for wiping the
unit. Do not use a damp cloth, thinner,
benzine, or other volatile solvents for
cleaning.
6) Wear ear protectors when using the
tool for extended periods.
bit becomes jammed,
II OPERATION
Hexagonal bit holder···(G)
1. Attaching the bits (Fig. 2)
NOTE: When attaching or removing
bit, be sure to set the main
switch lock at the lock position.
1. Hold the bit holder and pull it
against the driver.
2. Insert the bit into the hole of the
drive shaft.
3. The bit holder will return to its orig-
inal position when released.
4. Pull the bit to make sure it does
not come out.
5. To remove the bit, pull back on the
bit holder in the same way.
Clutch handle···(F)
(Clutch Torque Setting)
Adjust the torque to one of the 21
possible settings to the job. There is
an interval of about 0.13 Nm (1.3kg-cm
or 1.1 in-lbs) between steps. (Fig. 3)
CAUTION! Test the setting before
Reference for Adjusting Torque
Scale Torque
Approx: 0.29 Nm
1
(3.0 kgf-cm or 2.6 in-lbs)
Approx: 0.82 Nm
5
(8.4 kgf-cm or 7.3 in-lbs)
Approx: 1.35 Nm
9
(13.8 kgf-cm or 12.0 in-lbs)
Approx: 1.88 Nm
13
(19.2 kgf-cm or 16.6 in-lbs)
Approx: 2.41Nm
17
(24.6 kgf-cm or 21.3 in-lbs)
Approx: 2.94Nm
21
(30.0 kgf-cm or 26.0 in-lbs)
Approx: 4.4Nm
(45.0 kgf-cm or 39.0 in-lbs)
When use at high speeds, set the
B
scale at 10 or below. (Operation stops
at the maximum torque 1.5Nm (15kgf-
cm), when the scale is higher.)
The auto shut off function may become
B
inoperable at use at higher scales
when battery power drops. Recharge
the battery in that case.
NOTE: The chart is only a reference. The
torque setting may differ by mate-
rials, types of screws, etc. Please
test it at your own conditions
before use.
– 6 –
actual operation.
Use
For driving screws
For powerful driving
screws and drilling