Monitoring The Status Of An Account - Teldat VisorALARM PLUS 2U Operating Instructions Manual

6. Monitoring the status of an account

The VisorALARM PLUS 2U receiver includes an option to display the communication status of a
given account. This can be done through the "Account Status" option found in the receiver's "USER
MODE" menu.
The "ACCOUNT STATUS" menu is shown in the LCD display, as seen in the following figure:
The set of options included in the "ACCOUNT STATUS" menu is shown in the following figure:
1. The "State" option gives information about the connectivity state of the account. It displays a
screen as shown below:
The set of possible states are:
Device is all normal
Alive
Device is not connected
Registered
Device is not connected
Contacted
Device is not connected
Loss
signaled
Device is not connected
Changed
ACCOUNT STATUS
{State} Serial Sw Rls
State
Alive
State
Supervision messages for the device are received as
Device is present in the Account Database but no message
has been received from the device since last receiver reboot
Device is present in the Account Database and a "Contact"
message has been received. Receiver is waiting for
The timeout for the "KeepAlive" messages from the device
has expired. The receiver has raised a "Communications
A replacement of the device has been detected. The device
has been replaced without previously unregistering the
VisorALARM PLUS 2U Operating
III - 15
»
Description
expected.
"KeepAlive" messages from the device
Trouble" signal
account
Doc.DM375-I
Ver.1.0