Philips DVDR3590H Service Manual page 33

http://www.jdwxzlw.com/?fromuser=华盛维修
Firmware Upgrading & Diagnostic Software
Nucleus Name
Nucleus Number
Description
Technical
Execution Time
User Input
Error
Example
Nucleus Name
Nucleus Number
Description
Technical
Execution Time
User Input
Error
Example
Nucleus Name
Nucleus Number
Description
Technical
Execution Time
User Input
Error
Example
家电维修资料网，免费下载各种维修资料
DS_VIP_FastBlankingCheck
607
Checks the fast blanking signal on SCART2 in
- Read out the SCART1_P16 GPIO pin of the ASP
Less than 3 second
None
Number Description
60700 Value of Fast Blanking Pin is detected
60701 Error Cannot read Fast Blanking Pin
DS:> 607
060700: Fast Blanking is ON
Test OK @
DS_VIP_WssCheck
608
Check if the wide screen signal can be set low and high.
- Get the WSS Rear Y/C Out value
Less than 3 second
None
Number Description
60800
60801
DS:> 608
060800: WSS is ON
Test OK @
DS_VIP_DetectVideo
609
Checks if an active video signal is available on the CVBS input of SCART 1 or
SCART 2.
- Reset the VIP.
- Implement the following video route in the VIP : SCART1 (A32) to
ITU656_C
- Tell user to remove all active video input from SCART1.
- Enable sdtv(hlvln) mask in 0x500(First level interrupt enable) and 0x50d
(SDTV interrupt enable).
- Set GPIO 55 on ASP to input.
- Tell user to connect active video into SCART1.
- Read GPIO 55.
- The line should be LOW if there is active video on SCART1, else LOW.
- Clear the VIP *INTA interrupt.
Depending on user input
None
Number Description
609000 Detecting the Active video succeeded.
609001 Detecting the Active video failed.
609002 This test is not applicable for current HW layout.
609003 Could not retrieve hardware version from ASP.
DS:> 609
Please remove video input from the SCART1 connector.
Press any key when ready ...
Please input video input into the SCART1 connector.
Press any key when ready ...
609000: Active video is ON
Test OK @
3139 785 32804 5. EN 33