Water Supply - Candy GOY 0850 D User Instructions

The machine has an inlet hose with ¾" threaded ferrules
fitted to the ends to attach between the threaded connec-
tor on the appliance and the cold water supply.
The appliance must be connected to the water mains
using new hose-sets. The old hose-sets should not be
reused.
The appliance must only be connected to the cold water
supply.
Connection to a warm water supply, that is over 40°, may
damage certain delicate fabrics.
Note: it is advisable to turn off the tap after each
wash to isolate the washing machine from the water
supply.
If the inlet hose's connection point is changed, check that
the ¾" threaded ferrule on the inlet hose is firmly atta
to the electrovalve connector.
For the washing machine to function properly the terminal end of the discharge
hose (mouth) must be at a minimum of 50 cm and a maximum of 85 cm from the
ground.

Water supply

ched
47