Power And Battery Details - WowWee RS Media User Manual

POWER And bAttERy dEtAILs

This section describes the battery and power requirements for RS Media.
RS Media tells you when his batteries are running low, after which he will
shut down. When he does this, you will need to replace all the batteries
in the robot.
If RS Media is not responding well to controller commands, you might
need to replace the batteries in the controller.
RS Media
Battery requirements
Your RS Media is powered by 6 x "D" size batteries (not included) and 4 x
"AA" size batteries (not included). We recommend using only top-quality
alkaline batteries.
Power adapter
RS Media can be powered by an Output 7.5V AC/DC, 3.1 Amp,
center-positive adapter.
NOTE: Before operating RS Media using an adapter,
make sure that RS Media is turned off (button is set
to the OFF position).
To operate RS Media using an adapter:
1. Insert the jack of the adapter into the AC/DC socket in RS Media's
right foot (see RS Media Overview p.10)
2. Plug the adapter into a wall socket.
3. Turn RS Media on by setting the power button to the ON position.
NOTE: RS Media will only perform upper body and media functions
(i.e. he will not perform any leg actions or bend at the waist) when
being powered by an adapter.
Important power adapter information
Examine the AC/DC adapter regularly for damage to the cord, plug, enclo-
sure and other parts.
The AC/DC adapter is not a toy.
The toy must only be used with the recommended transformer.
If you wish to clean RS Media ensure that the power is disconnected first.
Wipe only with a soft dry cloth.
Battery installation
NOTE: Before installing or changing batteries, makes sure that RS
Media is turned off (switch is set to the OFF position).
To install or change batteries in RS Media:
1. On RS Media, locate the battery compartments
(on the underside of each foot).
2. Using a Phillips screwdriver (not included), remove the battery
compartment covers.
3. Insert batteries into the RS Media battery compartments as illustrated
in the diagram.
4. Replace the battery compartment covers and then replace the screws.
BottoM View of the rS Media
aC/dC adapter input