Battery Details And Powering On; Overview - WowWee Roboreptile User Manual

battEry dEtaiLs and pOWEring On

Battery requirements
Your remote controller is powered by 3 x "AA" size batteries
Your Roboreptile is powered by 6 x "AA" size batteries
(not included).
Battery installation
1 Before installing or changing batteries, ensure the Roboreptile's
ON/OFF button is in the OFF position.
2 Remove the battery compartment covers using a Phillips or
crosshead screwdriver (not included).
3 Insert batteries (not included) into the Roboreptile and
controller as shown in the diagrams.
4 Replace the battery compartment covers and the screws.
5 Press the ON/OFF button to the ON position.
Powering ON Attention: Important Battery Information
• Use only fresh batteries of the required size and recommended type
Roboreptile will perform a start-up • Do not mix old and new batteries, different types of batteries [standard
(Carbon-Zinc), Alkaline rechargeable] or rechargeable batteries of different
routine which cannot be interrupted
capacities
• Remove rechargeable batteries from the toy before recharging them
and will then wait for interaction.
• Rechargeable batteries are only to be charged under adult supervision
• Please respect the correct polarity, (+) and (-)
• Do not try to recharge non-rechargeable batteries
If no interaction is given for about
• Do not throw batteries into the fire
• Replace all batteries of the same type/brand at the same time
30 seconds, Roboreptile will
• The supply terminals are not be short-circuited
• Remove exhausted batteries from the toy
enter Free Roam Mode. • Batteries should be replaced by adults because of small parts
• Remove batteries if the toy is not going to be played with for some time
• The packaging should be kept since it contains important information
Bottom view of Roboreptile
(not included).
Battery
Compartment
1.5V LR6 "AA"
1.5V LR6 "AA"
1.5V LR6 "AA"
Bottom view of Roboreptile controller
Battery
Compartment
1.5V LR6 UM3 "AA"
1.5V LR6 UM3 "AA"
1.5V LR6 UM3 "AA"


OvErviEW

Infrared Vision Sensors
1.5V LR6 "AA"
Off On
Press once to
1.5V LR6 "AA" turn power on
1.5V LR6 "AA"
Stereo Sound Sensors
Touch Sensor

Remote Controller
Hood Accessory