Robopet™ Interaction; Advanced Interaction With Rs Media; Programming Capability; Directly Programming Rs Media - WowWee RS Media User Manual

AdvAnCEd IntERACtIOn WIth Rs MEdIA

Robopet™ interaction
Turn Robopet on, and then command him to sit down. Once he is sitting,
you should initiate the interaction routine within 10 seconds before he
enters Free Roam mode; otherwise, you will have to start the process
over.
NOTE: Robopet's Edge Detect switch must be set to the OFF position
to perform this interaction.
MODE BUTTON COMBINATION
Arm mode
Distance: Around 24"
Advanced interaction with Rs Media
This section describes advanced interactions you can have with your RS
Media. You can directly program RS Media (with or without the remote
controller) or take advantage of the RS Media Editing Suite software to
fully customize his features.

Programming capability

Any function from the Control or Arm mode function charts that can be
programmed in all program modes (except Puppet mode) are denoted
with the following symbol:
SYMBOL DESCRIPTION
Function is programmable.
+
RObOt IntERACtIOn/

Directly programming Rs Media

You can directly program RS Media or program him using the remote
controller. You can program RS Media directly in one of five (5) ways.
PROGRAMMING
MODE
Puppet mode
Main Program
mode
Sound Program
mode
Vision Program
mode
Editing Suite
NOTE: Media Mode functions cannot be programmed as a step in a
program.
NOTE: Program modes are disabled in Control Mode and Arm Mode
when audio is playing.
NOTE: All direct programming is stored on RS Media through Control
Mode and Arm Mode. Main Program, Sound Program and Vision
Program have two screens to indicate the mode in which you are
programming.

DESCRIPTION
Allows you to directly
program a sequence of
movements by manipulating
RS Media directly.
Allows you to program a
sequence of movements on
RS Media by using commands
from the remote controller.
Allows you to assign a
sequence of movements that
are triggered by a sharp sound
when RS Media is in Guard
mode. Refer to page 28.
Allows you to assign a
sequence of movements that
are triggered by a close-range
movement detected by the IR
sensor when RS Media is in
Guard mode. Refer to page 28.
Allows you to customize and
create your own Macros,
BodyCons, and Personalities
using the RS Media Editing
Suite, and upload them to your
robot. Use this software also
to manage files on RS Media.