Important Battery Information; Low Battery Indicators - WowWee MiP User Manual

Installing or changing batteries in MiP™:
1. To change the batteries, carefully lay MiP™ on its front. Do not place MiP™ where it could
easily fall. MiP™ requires 4 x "AAA" size alkaline batteries (not included).
2. Using a Phillips screwdriver (not included) remove the screws on the battery compartment
cover located on the back of the robot.
3. Insert the batteries according to the diagram. Ensure that the positive and negative polarities
match the illustrations inside the battery compartment.
4. Replace the battery compartment cover and tighten screws using the screwdriver. Do not
over-tighten.

IMPORTANT BATTERY INFORMATION:

• Use only fresh batteries of the required size and
recommended type.
• Do not mix old and new batteries, di erent types
of batteries
•
• Do not use Rechargeable batteries
• Please respect the correct polarity, (+) and (-).
• Do not try to recharge non-rechargeable batteries.
• Do not throw batteries into re.
• Replace all batteries of the same type/brand at
the same time.
• The supply terminals are not to be short-circuited.
• Remove exhausted batteries from the toy.
• Batteries should be replaced by adults.
• Remove batteries if the toy is not going to be
played with for some time.

LOW BATTERY INDICATORS:

When the batteries grow weak, MiP™ will move very slowly and easily fall down while moving
or turning. When this occurs, power OFF and replace all batteries.
NOTE: You will know when MiP™'s batteries are nearly depleted because it will make a low
battery indication sound and then power o . You can also see current battery levels via the
MiP™ App.
BATTERY INFORMATION
MiP™ Battery Diagram/Installation
2