Welcome Congratulations on purchasing your new Roboquad™ from Wowwee! Before using this product, carefully read this manual and retain it for future reference.
Roboquad Power on / off Remote controller Sleep and power down Low Power Stop and reset Roboquad overview Movement p.14 Controller overview Walking Roboquad infrared receiving range Independent leg movement Remote controller function chart Head movement Button overviews Rotation walking 1. Shift Personality settings 2. Personality settings - Activity, Aggression, Awareness p.15 - Activity, Aggression, Awareness Introduction 3.
Getting Started / Battery Details Remote controller Getting started To use your Roboquad, insert batteries (see below), turn him on, and then try Bottom view of remote controller some of his functions from the remote controller, or read on to discover more about the abilities of this friendly alien invader.
Buttons Overview Activity LED Activity button 1. Shift Aggression LED Aggression button Shift levels Awareness LED Awareness button The tricolor LED shift light indicates the shift layer in use. There are 4 levels: Level 1 Unshifted Level 2 Shift-Green Level 3 Shift-Orange Level 4 Shift-Red...
Buttons Overview 3. Program button and Program play button Program button Program play button Program button Program play button Unshifted Program Program play Autonomy button Shift-Green Program back Sound & vision sensors On/Off Shift-Orange Program erase Dizzy BodyCon Shift-Red Volume down Volume up 4.
Buttons Overview Shift button Forward Top right Top Left Right Left Bottom right Bottom left Backward 8. Directional pad Forward Backward Right Left Top right Top left Bottom right Bottom left Unshifted Walk forward* Walk backward Right crab walk* Left crab walk* Top right shuffle Top left shuffle Bottom right shuffle...
Press once to make Roboquad enter sleep mode. Press the motion associated with a specific sound. stop button at any shift layer to wake up Roboquad (none of his user programming will be affected). Power on / off Power down Roboquad’s power button is located on his back.
Walking Head movement You can make Roboquad walk in a variety of ways by pressing the directional In shift-red, forward and backward will move Roboquad’s head up or down, and pad in 4 directions (forward, backward, left and right) when unshifted or in the rotate clockwise/counter-clockwise buttons will turn his head left or right.
If Roboquad does not receive the signal, his personality This button will toggle through Roboquad’s awareness personality settings. will not be altered but the controller will think it has. If this occurs, Roboquad This affects the range of his scanner and how much he uses it in autonomous will update his on-board personality with the controller the next time a mode.
Page 18
• program playback • guard mode Sound sensor Roboquad will react to sharp sounds when his sound sensor is turned on and he is not moving. Roboquad’s sound sensor is on during: • autonomous mode during rest periods • guard mode (when he is not moving) •...
Page 19
When Roboquad is put into guard mode, he will give you a short time to leave Exiting guard mode the area (around 7 seconds) before he fully enters guard mode. He will do this Roboquad can exit from guard mode in four ways: by counting down and performing an entry alert sound.
Page 20
Volume up Scan (left/right) for nearest object Using this scan, Roboquad will look for the nearest object and turn to face it. He Roboquad’s volume can be adjusted using the program buttons in shift-red. There will start scanning from side to side using his medium range scan, with his head are 4 volume level settings: mute, low, medium and high.
Page 21
Roboquad will perform the move and confirm it with an “affirmative” Pressing the program play button will exit Roboquad from program mode, sound. Roboquad will add each new command you enter to the end of the playing a program if one is stored.