Before Starting; Connecting The Device; Getting Ready; For Contactless Transactions - First Data FD35 PIN Pad Quick Setup Manual

Before Starting

The First Data FD35 has a hard-wired power and signal cable
with a female mini-DIN connector. Connection to a PC or a
First Data FD terminal requires an adapter cable with a male
mini-DIN connector at one end and a USB connector at the other.

Connecting the Device

J Make sure the terminal is powered off
J Insert the interconnect cable's USB plug
into the USB port located on the back of
the terminal
J Connect the opposite end of the interconnect
cable to the cable that is attached to the FD35
J Once the cables are fully connected, power up
the terminal
Page 3 :
Need Additional Assistance?
Getting R eady
Please contact the Merchant Services Group. For online customer
service support 24/7/365, log onto MerchantInsider.com
The u nit a utomatically s tarts u p w hen c onnected t o t he P C/terminal. I t w ill d isplay a s tatus m essage
until i nitialized b y t he t erminal o r P C.

Getting Ready

The unit automatically starts up when connected to the
Using t he D evice
terminal/PC. It will display a status message until initialized
by the terminal or PC.
For c ontactless t ransactions:

For Contactless Transactions

Only c ontactless-­‐equipped c ards/devices, w hich a re m arked w ith t his i con
•
Only contactless-equipped cards/devices,
contactless t ransactions w ith t he F D35
which are marked with this icon
The c ardholder w ill t ap h is o r h er c ontactless c ard/device a gainst t he c ontactless i con
•
contactless transactions with the FD35
located o n t he F D35 ( as s een i n t he i mage t o t he r ight)
The cardholder will tap his or her contactless
Visual a nd a udio p rompts w ill i ndicate e ach s tep o f t he p ayment p rocess
•
card/device against the contactless icon
located on the FD35 (as seen in the image to
the right)
Visual and audio prompts will indicate each step of the
payment process
Swipe or tap card Yellow lights up
while reading
card information
can make
Card read and
OR
sent to the
terminal for
processing
Plug in
PIN pad here
can m ake
Error message.
card not read,
please present
the card again
can m ake